Descargar Imprimir esta página

Celexon Mobil Expert Serie Manual De Instrucciones página 13

Pantalla de marco plegable proyección frontal/ trasera

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
falling from even a small height.
Keep the product away from moisture and heat.
Never immerse the product in water or other liquids.
Only use the product in its intended manner. Any other use may result
in damage to the product or its surroundings.
Tighten the screws but do not over tighten them. Overtightening can
cause damage and may affect the secure fit of the screen.
Failure to follow the above instructions may result in personal injury
and damage to the product or equipment connected to it. Incorrect
installation or use may also invalidate the warranty.
If you are unsure about the use of the product, please contact your
specialist personnel, your dealer or celexon directly (Web: www.ce-
lexon.co.uk, Mail: info@celexon.co.uk)
Technical changes and errors excepted.
The manufacturer accepts no responsibility for damage to property or
personal injury if the screen is used outside the recommended specifica-
tions, or in the event of improper installation. Do not use this screen near
heaters or air conditioners. Use the product in direct sunlight only to a
limited extent, the PVC material may deform and affect flatness. If the
screen is very warm after use in the sun, wait until it has cooled down to
room temperature (approx. 18-24°) and is always completely dry before
folding and packing it.
We recommend that you keep the fabric in a warm room for a few hours in
cold conditions to soften the material making it easier to fit.
Please avoid any stains on the surface of the cloth. These may not be able
to be removed.
Note the front and back of the fabric when attaching.
Please check ALL parts for damage before assembling.
The screen must ONLY be assembled on a soft, cushioned surface. The
frame coating may otherwise be scratched.
For permanent flatness, please observe the following instructions
1.
Do not touch the projection screen surface with your hands.
2.
Do not fold the projection screen surface when it is cold (below 10°C)
or very warm (above 30°C).
3.
Do not paint or write on the projection screen surface.
2

Publicidad

loading