HIKOKI RP 350YBL Instrucciones De Manejo página 4

English
WARNING - If any foam or
water egresses, switch off
immediately. Empty the container
and, if need be, the pleated filter.
Never sit or stand on the device.
Always set up the connection lead
and hose so there is no danger of
tripping.
Do not pull the connection lead
over any sharp edges and do not
kink or pinch it.
If the connection lead of the device
is damaged, it must be replaced by
a special connection lead. See the
chapter on Repairs.
Always connect to a socket with
protective contact.
Do not use any damaged
extension leads.
Never insert or remove the mains
plug with wet hands.
Only pull on the mains plug, not on
the lead.
WARNING - The plug socket on
the device must be used only for
the purposes defined in the
operating Instructions.
Do not leave the device
unattended. If there is a long work
interruption, disconnect the mains
plug.
The dust extractor should not be
used or stored outside in wet
conditions.
IMPORTANT - This device must
only be stored indoors.
Acids, acetone and solvents can
corrode the device components.
4
P rior to any servicing work,
clean the device. Switch off the
device after each use and pull out
the mains plug.
Steam cleaners and high-pressure
cleaners must not be used to clean
the dust extractor.
The inside of the cover must
always be kept dry.
Mould contamination can result if
the device is not cleaned for an
extended period, especially if used
in areas where foodstuffs are
processed: Always clean and
disinfect the dust extractor immedi-
ately after use.
Never open the device outdoors
during rain or storms.
Do not use the device outdoors in
cold weather.
The device must not be operated in
areas with an explosion hazard.
Ensure that the dust extractor is
steady.
If the extracted air is discharged
into the room, ensure there is an
adequate air change rate (L) in the
room. Observe the regulations that
apply in your country.
Keep the tool socket dry and do not
expose to moisture.
Do not plug extension cords
between the dust extractor and the
power tool.
When using the tool socket, use
the dust extractor in a dry environ-
ment.