Publicidad
REMOTE CONTROL UNIT OPERATION
Elapsed time of
Remaining time of currently
currently playing
->
playing track (not displayed
track
for tracks 30 and above)
it
L
Total time and
Remaining time on disc (or
total number of
| <
programmed tracks); does not
tracks on disk.
display during random
playback
@ "AL" is displayed.
[}
Program button:
Use to program disc tracks in any
desired order of playback.
Random button: When this button is pressed, the CD
player plays back all tracks on the disc in random order.
When pressed during program playback, the program
is canceled and random playback begins.
Edit button: Used for auto program edit (see page 34).
@ PIONEER
Symuum Remote Control Lit
D. Tape deck (T-C3) operation buttons
(=) ()
Playback buttons:
Press to begin playback in the
indicated direction.
(=)
Stop button: Press to stop tape travel.
([] ©)
Fastforward buttons: Press to fast forward the tape in
the indicated direction. These buttons can also be used
to perform music search (see tape deck's Operating
.
Instructions).
(2)
'Recording muting button: When this button is pressed,
a four-second non-recorded interval is created, after
A. Amplifier operation buttons
which the tape deck enters the recording standby mode.
selector buttons on the main unit.
(2) _— Pause button:
Press to pause playback or recording.
Press again to resume playback or recording.
Power
C=] _~—sw Recording button: Press to set to the recording mode;
O
Power button:
Use to switch the amplifier's power
then, press the play button to begin recording.
between on and standby.
SS
eee
Use to adjust the volume level.
This unit's remote control unit can be used in one of
the two following ways:
B. Tuner (F-C5RDS/F-C3) operation buttons
C=7°t4)
Station buttons:
Use to call out broadcast stations.
C.
CD Player (PD-C5/PD-C3) operation buttons
cm)
Stop button:
Press to stop playback.
CG)
Play button:
Press to begin play.
a)
Track search buttons:
<4: When this button is pressed, play returns to the
beginning of the currently playing track; when pressed
repeatedly, play returns to previous tracks.
bP: When this button is pressed, play advances to the
beginning of the next track; when pressed repeatedly,
1. To operate the component itself
2. When this component is connected by system control cables
to other Pioneer components (F-C5RDS/F-C3, T-C3, PD-C5/PD-
C3), the remote control unit can be used for central system
lay
ad
to
sub
t track:
behabe
PIS y SGNSHECS
(0) Sp ecrnon
nn
acne
(Aim the remote control unit at the amplifier's signal receiver
Time button:
When this button is pressed, The CD
to control all components.)
player's display section switches as follows:
24
<ARE7009>
En
Publicidad
