Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and connection
9.
Examine your microwave oven
Unpack the oven, remove all packing material, and
examine the oven for any damage such as dents,
broken door latches or cracks in the door. If you find
any damage, notify your dealer immediately. Do not
install a damaged microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE PROPERLY
EARTHED FOR PERSONAL SAFETY.
If your AC outlet is not grounded, it is the personal
responsibility of the customer to have it replaced
with a properly grounded wall socket.
Operation voltage
The voltage has to be the same as specified on the
label on the oven. If a higher voltage than specified
is used, it may cause a fire or other damages.
Placement of the Oven
1. Place the oven on a flat and stable surface.
2. When this oven is installed, it should be easy to
isolate the appliance from the electricity supply by
pulling out the plug or operating a circuit breaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
Counter-top use:
a. Allow 15 cm of space on the top of the oven,
10 cm at back and 5 cm on both sides.
b. If one side of the oven is placed flush to a wall,
the other side or top must not be blocked.
Nay
SS
Built-in:
This oven may be built into a wall cabinet by
using the proper trim kit (NN-TKK55),
which may be purchased from a local Panasonic
dealer.
Do not place this oven near an electric or gas
cooker range.
5. The feet should not be removed.
6. This oven is only for household usage. Do not use
outdoors.
7. Avoid using the microwave oven in high humidity.
8. The power cord should not touch the outside of
the oven. Keep cord away from hot surfaces. Do
not let cord hang over the edge of table or work
top. Do not immerse cord, plug or oven in water.
Do not block the air vents on the top and back of
the oven. If these openings are blocked during
operation the oven may overheat. In this case the
oven is protected by a thermal safety device and
resumes operation only after cooling down.
Safety Instructions
Service
t.
4.
eae
2.
3.
The door seals and door seal areas should be
cleaned with a damp cloth.
The appliance should be inspected for damage to
the door seals and door seal areas and if these ©
areas are damaged the appliance should not be
operated until it has been repaired by a service
technician trained by the manufacturer.
. Do not operate this appliance if it has a damaged
CORD OR PLUG, if it is not working properly, or if
it has been damaged or dropped.
It is dangerous for anyone other than a service
technician trained by the manufacturer to perform
repair service.
. Do not attempt to tamper with or make any
adjustments or repairs to door, control panel
housing, safety interlock switches or any other
part of the oven. Do not remove outer panel from
oven.
Repairs should only be done by a qualified
service person.
If the supply cord of this appliance is damaged, it
must be replaced by the special cord available
from the manufacturer.
When it becomes necessary to replace the oven
light, please consult your dealer.
Use of your oven
1.
Do not use the oven for any reason other than the
preparation of food. This oven is specifically
designed to heat or cook food. Do not use this
oven to heat chemicals or other non-food
products.
Before use, check utensils/containers are suitable
for use in microwave ovens.
Do not attempt to use this microwave oven to dry
newspaper, clothing or any other materials.
They may catch on fire.
. When the oven is not being used, do not store any
objects other than oven accessories inside the
oven in case it is accidentally turned on.
. The appliance shail not be operated by
MICROWAVE WITHOUT FOOD IN THE OVEN,
operation in this manner may damage the
appliance.
. ff smoke or a fire occurs in the oven, press the
STOP/CANCEL Pad or turn TIMER/WEIGHT
SELECT
DIAL back to zero
position and leave
door closed. Disconnect the power cord, or shut
off power at fuse or circuit breaker panel.
Publicidad
