Publicidad
Idiomas disponibles
Idiomas disponibles
CARTRIDGE
INSTALLATION
A cartridge weighing between 4 - 10 g can be mounted with the
supplied
Shell (7.5 g).
Heavier
cartridges
from
10-15.5g
can
be mounted
using the Extra Counterweight
(supplied).
If another shell is to be installed,
use
one
whose
weight
and
height are the same
as that of the supplied Shell.
@ Select the most suitable length of cartridge mounting screws
according
to
the
height
of
your
cartridge.
(Three
pairs
of
screws of various lengths
are supplied.)
@ Install
the
cartridge
with
the
selected
screws
so
that
the
distance
between
the
shell
end
and
the
stylus
tip is 49mm
(1 15/18").
The
temporary
overhang
adjustment
is then
com-
plete.
More
precise adjustment
should
be made
later.
@lf the front edge of the Shell
blodks the cartridge,
and
the
required
distance
cannot
be obtained
insert the supplied spacer
under the Shell.
Fasten the screws lightly
so that the cartridge can be
Oy
slid for adjustment.
ee
So
a
jw
4.9mm (1 1%6 esl
© Connect
the
lead
wires
of the
Shell
to the
corresponding
pins
on the cartridge.
Wires
Cartridge
pins
White
........
L (left channel
signal)
Blue..........
LE or G (left channel
ground)
Red +)... ta «erie
R (right channel
signal)
Green.........
RE or G (right channel
ground)
e@Shell
stands
are
provided
on
the base
of the turntable for
an
extra
mounted
cartridge.
TONEARM
ASSEMBLY
AND
ADJUSTMENT
Do not connect the power cord or the connecting
cords
until
the assembly
and
adjustments
are complete.
The following procedures should be performed on a level surface.
Be careful not to damage
the stylus tip while
making
adjust-
ments.
When a cartridge is replaced, readjustments are required.
Preparation
@ Secure
the Tonearm
to the Arm
Rest and lower
the Cueing
Lever.
@ Plug the Shell into the Tonearm
and turn the Locking Collar
counterclockwise
until the Shell is firmly locked.
© Insert
and
turn
the
Counterweight
counterclockwise
several
turns.
(The Tracking-force
Ring turns
simultaneously.)
elf the cartridge weight is from
10-15.5g,
add the supplied
Extra Weight
at the arm
pipe end.
@ Remove
or lift up the stylus guard,
if fitted.
Counterweight
Tracking-force
a]
Extra Weight
Match
the guide pin on the
Shell with the upper slot
Anti-skating
Compensator
Longitudinal
balance
adjustment
*1
@ Be sure that the Anti-skating Compensator
is set at "0".
Release
the Tonearm
from
the Arm
Rest.
Pull up the upper portion
of the Arm
Rest
and turn
it clockwise so that you
can
perform
the adjustment easily.
Publicidad
