HIKOKI UB 18DG Instrucciones De Manejo página 11

*6 Precautions when retracting the tripod
WARNING
○ Be careful not to pinch your hands or fi ngers in the
sliding parts during operation.
*7 Transporting the tripod
WARNING
When moving or transporting the tripod light:
○ Turn off the switch, and detach the rechargeable battery
and LED driver from the tripod light.
○ Place the LED unit back inside its storage cover.
○ Secure the locking levers (A) and (B).
○ Fold up the tripod.
○ Close the battery cover.
<Using the carrying handle> (Fig. 11-a)
NOTE
○ Hold the tripod so that the LED unit is pointing forward.
○ Hold the tripod at the rear of its carrying handle, taking
care not to press the leg opening lever.
<Using the bag (sold separately) and shoulder strap
(included in bag sold separately)> (Fig. 11-b)
NOTE
Use only the specifi ed HiKOKI bag (sold separately) and
shoulder strap (included in bag sold separately).
○ Detach the shoulder strap fi tted to the bag (sold
separately), and attach it directly to the hook attachment
on the tripod light. (Fig. 11-c)
○ Hold the carrying handle when carrying the tripod, as it
will swing about if using only the shoulder strap (included
in bag sold separately). (Fig. 11-c)
*8 If the sliding parts become loose with use, adjust by
retightening the screws.
If the upper screw alone is not suffi cient to retighten,
adjust the lower screw. (Fig. 12-b)
MAINTENANCE AND INSPECTION
WARNING
When not using the tripod light for a long time, or when
performing maintenance on it, inspecting it, or storing it,
be sure to turn OFF the switch and detach the LED driver
and the battery.
1. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
2. Inspection of terminals (tool and battery)
Check to make sure that swarf and dust have not
collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have collected on
the terminals.
Failure to do so may result in malfunction.
3. Cleaning on the outside
When the cordless tripod light is stained, wipe with a
soft dry cloth or a cloth moistened with soapy water.
Do not use chloric solvents, gasoline or paint thinner, for
they melt plastics.
4. Storage
Store the cordless tripod light and the battery in a place
in which the temperature is less than 40°C and out of
reach of children.
NOTE
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signifi cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
However, signifi cantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to fi ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
and purchase new batteries.
Important notice on the batteries for the HiKOKI
cordless tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless tool when used with
batteries other than these designated by us, or when
the battery is disassembled and modifi ed (such as
disassembly and replacement of cells or other internal
parts).
GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a HiKOKI Authorized Service Center.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
11
English