Alpina PTC-2021 WIFI GLASS Manual De Instrucciones página 8

INSTALLATION
Drill two holes in the wall and have a distance of above 2.0m from the
ground. Make sure the diameter of the holes are 6 mm so the plugs
will fit. Place the plug in the holes. Insert the screwes in the plugs.
Hang the heater on the screws, push to the right and then down to
secure the heater (see the picture A / B). Insert the power plug into the
socket. Your electric heater is now ready for operation.
Note: max weight is 4.1kg, the wall should be able to carry this
weight.
1. The distance between the product and
the ceiling(and the side) should be
≥30cm.
2. The screw can stick out 10 mm out of the
wall so the heater can get enouf support.
3. Note: when the product is installed, The
hook (screw) is aligned with the hole "A"
on the product. After hanging, must be
moved to the "B", in order to firmly fix.
When to remove the product, must be
moved from «B» to «A» then take out.