Publicidad
Idiomas disponibles
Idiomas disponibles
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
6. Place two clips (BB) along the bottom of each side of
the housing (A) to hold the housing (A) in place. Mount
the housing (A) to the joist.
Note: The clips (BB) will ensure the bottom edge of the
housing (A) is flush with the ceiling board.
Hardware Used
eclip~
x4
7. Use long screws (AA) to screw the housing directly into
the joist through the holes on either side of the housing
(A). One side of the housing has four holes and the other
side of the housing has three holes. Choose a side that
works best for the installation area.
Note: The bottom edge of the housing (A) must be flush
with the finished ceiling.
Hardware Used
•
Long Screw
ij})ll)l)))))j)))))))))))))))jD>
x 3
or 4
8. Connect the wiring according to the wiring diagram.
a. Connect the black wire from the fan to the black wire from
the fan switch with two-port quick connect (GG).
b. Connect the black wire from the light to the black wire from
the light switch with two-port quick
connect
(GG).
c.
Connect the white wire from the fan to the white wire from
the light and connect to the line in from the ceiling with
three-port quick connect (H H).
d. Connect the the red wire from the light to the red wire from
the nightlight
switch
with two-port quick connect (GG).
e. Connect the ground/green wire from the unit to the ground
bare wire in the ceiling with two-port quick connect (GG).
Note: For single wall
switch
applications, remove and cut
the clear 2 port connectors from the 2 black wires coming
from the bath fan chassis. Strip 1/2 in. of insulation from the
wire ends and connect both black wires to the single black
wire
coming
from the
ceiling/switch.
To use the red wire/
nightlight,
an additional
switch will
be
needed.
15
4 holes
~
UTILITECH'
]
Lowes.com
l!l)
- · - :
Publicidad
