Publicidad
Idiomas disponibles
Idiomas disponibles
NEW CONSTRUCTION INSTALLATION INSTRUCTIONS
1. Use long screws (AA) to screw the housing (A) directly
to the joist using keyhole mounting tab holes or the
holes on the inside of the housing (A). One side of the
housing (A) has four holes and keyhole mounting slots,
the other side of the housing (A) has three holes.
Choose the side that best works for the installation area.
Note: The bottom edge of the housing (A) must be flush
with the finished ceiling.
Hardware Used
•
Long Screw
~\D)))ll))l\ll))l\ll)II)))\}Jl>
x 3
or 4
2. Loosen the housing screws (JJ) and extend the hanger
bars (D) to the joist.
Hardware Used
•
Housing Screw
@)mi D
x2
3. If the joist space is less than 15 in., connect the inside
and outside pieces of the hanger bar (D) at hole A. If the
joist space is from 15 in. to 20 in., connect the inside and
outside pieces of the hanger bar (D) at hole B. Tighten
the housing screws (JJ) on the inside of the housing (A).
Secure the hanger bars (D) to the joist using long screws
(AA).
Hardware Used
Long Screw
~))lll)\l))))\))\l)))lll]))j})J>
x2
Housing Screw
@)mi D
x2
7
D
4
holes
r -
joist space
r -
0
II
=::::::)
c:
:l.
-
-
..... T
""
-
.
~\
·.
-
•
'--
'--
~
UTILITECH'
]
Lowes.com
l!l)
- · - :
Publicidad
