without supervision. Keep packaging films out of the hands of children. There is a
danger of suffocation.
Important safety information for the batteries
WARNING!
Keep new and old batteries out of reach of small children. If a battery is swallowed,
seek medical attention immediately.
Always insert the batteries with the correct polarity. Clean the batteries and device
contacts beforehand if necessary. Do not attempt to recharge, short circuit, or open
the batteries. Never heat the batteries to recharge it. Never expose the batteries to
excessive heat such as sunshine, fire or similar as there is an increased risk of
leakage. Never throw the batteries into fire as it may explode. Improper use of the
batteries may cause explosion and leakage of battery fluid.
If the batteries leak, avoid contact with skin, eyes, and mucous membranes. Wear
gloves. In case of accidental exposure to battery fluid, rinse the affected areas with
plenty of clean water and seek medical attention immediately. Remove the flat
batteries from the device immediately as there is an increased risk of leakage.
Securely placing or mounting the weather station
The weather station with outdoor sensor is not designed for operation in rooms with
high humidity (i. e. bathroom). Use the supplied rawlplug and screw for wall
mounting. Make sure that:
sufficient ventilation is always guaranteed (don't place the device on shelves or
where curtains or furniture block the ventilation holes, and ensure that there are at
least 10 cm of space on all sides);
the device isn't placed on a thick carpet or bed during operation, no direct heat
sources (i.e. radiators) influence the device;
no direct sunlight reaches the device;
contact with splashing or dripping water must be avoided (don't place any items
filled with liquids, i.e. vases, onto or next to the device);
the device doesn't stand near magnetic fields (i.e. speakers);
no foreign objects or dust penetrate the housing;
candles and other open flames must be kept away from this product at all times to
prevent the spread of fire.
Securely placing or mounting the outdoor sensor
Place the sensor in a location where it is protected from the weather, for example
under an awning or carport. The sensor has an IPX4 rating and is therefore
protected from water splashes. Use the supplied rawlplug and screw for wall
mounting. Make sure that:
the sensor hangs or stands upright;
sufficient ventilation is always guaranteed (don't place the device on shelves or
where curtains or furniture block the ventilation holes, and ensure that there are at
least 10 cm of space on all sides);
no direct sunlight reaches the device;
the device doesn't stand near magnetic fields (i.e. speakers);
no foreign objects or dust penetrate the housing;
sensitive surfaces are protected before placement.
HEALTH HAZARD!
RISK OF EXPLOSION!
- 29 -