Style selections F13-I-002-023B Manual Del Usuario página 13

OPERATING INSTRUCTIONS
3b. Flame: Press to activate the flame function. This
button controls the brightness of flame and ember
effect. When the fireplace is first turned on, the flame
will come on at the highest setting; keep pressing to
adjust the brightness of flame. There are 6 levels you
can cycle through, including the OFF setting (the ember
remains on). When adjusting the flame brightness,
the display lights below button correspond to its 5
brightness levels.
3c. Heater: Press to activate the heater function. When
the fireplace is first turned on, the temperature will
come on at the highest setting; press second time
to activate low heat setting, and press third time to
activate auto heat setting. When adjusting the heat
setting, the display lights below button correspond to its
3 levels.
3d. Temperature setting control: Use rotary switch to
set desired temperature. When the room temperature
is lower than the set temperature by less than 6 degree
Fahrenheit, firepalce will start only one heat generator,
this is same as low heat setting (750W); When the
room temperature is lower than the set temperature
by 6 degree Fahrenheit or greater, fireplace will start
both heat generators, this is same as high heat setting
(1500W); When the room temperature is higher than
the set temperature, firepalce will shut down both heat
generators.
Note: Set temperature button can only be used when in
auto mode.
3b
POWER
a 3c
POWER
3d
POWER
13
FLAME
HIGH LOW
FLAME H. L. AUTO. SET TEMP. °F
H. L. AUTO.
HIGH LOW
FLAME H. L. AUTO. SET TEMP. °F
HIGH LOW
SET TEMP. °F
LOW
HIGH
FLAME H. L. AUTO.
SET TEMP. °F
Lowes.com