Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO SET UP YOUR
UNIT
Air Compressor
Location
•
Locate the air compressor in a
clean, dry, and well ventilated
area.
•
Locate the air compressor
at
least 12" away from the wall or
other obstructions
that will
interfere with the flow of air.
•
Locate the air compressor
as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE: Long lengths of electrical
wiring could cause power loss to
the motor.
•
The air filter must be kept clear
of obstructions
which could
reduce air flow to the air
compressor.
Anchoring
of the Air
Compressor
_
Excessive
vibration
can weaken the air
tank and cause an explosion. The
compressor must be properly
mounted,
The air compressor
MUST be bolted
to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not
supplied)
4 - 3/8" Lag screw to fit
concrete anchors (not
supplied)
4 - 5/8" Washer (found in parts
bag)
- shims (if needed)
1.
Place the air compressor on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor
feet as a
template.
3.
4.
5.
Drill holes in the surface for the
concrete anchors. Install
concrete anchors.
Line up holes in surface with
holes in air compressor feet.
Place the (4) washers (supplied)
between the floor and air
compressor
feet. If needed, solid
shims may be placed between
the washers and floor to evenly
distribute weight on all four feet.
See next figure.
3/8" Lag
//
I
Screw
_
_(not
5/8" Washer ¢/
,j
supplied)
(supplied)
[__
_
Surface Line
Shim Under
Washer
Co_crete Anchor
(not supplied)
(not supplied)
6.
7.
Place the (4) 3/8" lag screws
through the air compressor feet,
washers, shims, and into the
anchors.
Torque 3/8" lag screws to 7-10
ft.-Ibs.
Wiring
Instructions
I_-J_-;_
Risk of Electrical
Shock.
Improper
electrical grounding can result in
electrical shock. The wiring should
be done by a qualified electrician.
A qualified electrician needs to know
the following before wiring:
1.
The amperage rating of the
electrical box should be
adequate.
Refer to the
Specification
Table, in this
manual, for this information.
11_ ENG
D30091
Publicidad
