Publicidad
Idiomas disponibles
Idiomas disponibles
Air Filter Inspection
and
Replacement
Risk of Burns.
Compressor head
and cylinder sleeve are very hot.
Do not touch. Allow compressor to
cool prior to servicing.
A dirty air filter will not allow the
compressor to operate at full
capacity.
Keep the air filter clean at
all times.
1.
Remove
the air filter
cover.
2.
Remove
the air filter
from filter
cover.
IMPORTANT:
Do not operate
the compressor with the air filter
removed.
3.
Place new air filter into filter
cover. Refer to the "Repair Parts"
for the correct part number.
4.
Replace air filter cover and lock
into place.
Motor
Pulley/Flywheel
Alignment
NOTE: Once the motor pulley has
been moved from its factory set
location, the grooves of the flywheel
and pulley must be aligned to within
1/16" to prevent excessive belt wear.
The air compressor
flywheel and motor
pulley must be in-line (in the same
plane) within 1/16" to assure belt
retention within flywheel belt grooves.
To check alignment, perform the
following steps:
1.
Disconnect
electrical supply to the
air compressor
2.
Remove belt guard.
3.
Place a straightedge
against the
outside of the flywheel and the
motor drive pulley.
4.
Measure the distance between the
edge of the belt and the
straightedge
at points A1 and A2
in figure.
The difference between
measurements
should be no more
than 1/16".
5.
If the difference is greater or tess
than 1/16" loosen the set screw
holding the motor drive pulley to
the shaft and adjust the pulley's
position on the shaft until the A1
and A2 measurements
are within
1/16" of each other.
6.
Torque the motor drive pulley set
screw to 70-80 in.-Ibs.
7.
Visually inspect the motor drive
pulley to verify that it is
perpendicular
to the drive motor
shaft. Points B1 and B2 in figure
above should appear to be
equal.
If they are not, loosen the
setscrew of the motor drive
pulley and equalize B1 and B2,
using care not to disturb the belt
alignment performed in step 4.
8.
Retighten the motor drive pulley
set screw to 70-80 in.-Ibs.
9.
Reinstall belt guard.
Air Compressor Pump Intake
and Exhaust Valves
Once a year have a Trained Service
Technician check the air compressor
pump intake and exhaust valves.
Inspect Air Lines and Fittings
for Leaks
1.
Turn the air compressor on to
inspect for air leaks.
2,
Apply a soap solution to all air
line fittings and
connections/piping.
Bubbles will
indicate a leak.
3.
Correct any leaks found.
IMPORTANT: Even minor leaks can
cause the air compressor
to
overwork, resulting in premature
breakdown or inadequate
performance.
19_ ENG
D30091
Publicidad
