Publicidad
Idiomas disponibles
Idiomas disponibles
3. Slide a
wheel over the axle.
NOTE: Be sure to installboth wheels with the air
pressure valve on the outboard side.
4.
Retain wheel on axle with the retaining pin.You may
acid the fiat washer if desired.
5.
Repeat step 3 and 4 to secure second wheel.
6.
Remove the temporary blocks.
7.
To aid support leg assembly,rest generator on cradle,
engine end down.Attach the support leg with two
M8 x 16mm cap screws and two locking hex nuts as
shown.
8.
Use two 13 mm wrenches to tighten leg hardware.
Rest generator on wheels and support leg.
9.
Center the handle bracket on generator frame at
support leg end of cradle, as shown.
10. Attach handle bracket with two M8 x 45mm cap
screws and two locking hex nuts.
I I. Check that all fasteners are tight and the tires are
inflated between 15-40 PSI.
BEFORE
STARTING
THE
ENGINE
Add Oil
CAUTION!
Any attempt to crank or start the engine
before it hasbeen properly filled with the recommended
oil may result in an engine failure.
To fill your engine with oil:
• Placegenerator on a level surface.
• Follow the oil grade recommendations and oil fill
instructionsgiven in the engine owner's manual.
NOTE:The generator's revolving field rides on a
prelubricated and sealed bali bearing that requires no
additional lubrication for the life of the bearing.
Add Gasoline
_
ARNING!
Never fill fuel tank indoors.Never
fill fuel tank when engine is running or hot.Allow
unit to cool for two minutes before refueling. Do
Not light a cigarette or smoke when filling the fuel
tank.
_
WARNING!
Do Not overfill the fuel tank.
Always allow room for fuel expansion.
• Use regular UNLEADED
gasoline with the generator
engine. Do Not
use premium gasoline. Do Not
mix oil
with gasoline.
• Clean area around fuel fill cap, remove cap.
• Slowly add unleaded regular gasoline to fuel tank. Be
careful not to overfill.Allow
about 1.5" of tank space for
fuel expansion (Figure 2).
Fuel
......
• Install fuel cap and wipe up any spilled gasoline.
IMPORTANT:
It is important
to prevent gum deposits
from forming in essential fuel system parts, such as the
carburetor, fuel filter, fuel hose or tank during storage.Also,
experience
indicates that alcohol-blended
fuels (called
gasohol, ethanol or methanol) can attract moisture, which
leads to separation and formation
of acids during storage.
Acidic fuel can damage the fuel system of an engine while in
storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 clays or longer. See "Storage"
on page I I. Never
use engine or carburetor
cleaner
products in the fuel tank or permanent
damage may occur.
/
6
Publicidad
