Publicidad
Idiomas disponibles
Idiomas disponibles
POWER CONNECTIONS
A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should
be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have
3-prong grounding type plugs and matching receptacle which will accept the machine's plug. Before connecting
the
machine to the power line, make sure the switch (s) is in the "OFF" position and be sure that the electric current is of
the same characteristics
as indicated on the machine. All line connections should make good contact. Running on low
voltage will damage the machine.
Do not expose the machine to rain or operate the machine in damp locations.
MOTOR
SPECIFICATIONS
Your machine is wired for 120V, 60 HZ alternating current. Before connecting the machine to the power source, make
sure the switch is in the "OFF" position.
GROUNDING
INSTRUCTIONS
This machine must be grounded while in use to protect the operator
from electric shock.
1.
All grounded,
cord=connected machines:
In the event of a malfunction
or breakdown, grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This machine is equipped with an electric cord having an equipment-grounding
conductor
and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
Do not modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified electrician.
Improper connection
of the equipment-grounding
conduc-tor
can result in risk of electric shock. The conductor
with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding
conductor.
If repair or replacement
of the electric cord or plug is necessary, do not connect
the equipment-
grounding conductor to a live terminal.
Check
with a qualified
electrician
or service
personnel
if the grounding
instructions are not completely
understood, or if in doubt as to whether the machine is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding type plugs and matching 3-conductor
receptacles that
accept the machine's plug, as shown in Fig. A.
Repair or replace damaged or worn cord immediately.
2.
Grounded,
cord=connected
machines
intended for use on a supply circuit having a nominal rating less
than 150 volts:
If the machine is intended for use on a circuit that has an outlet that looks like the one illustrated in Fig. A, the
machine will have a grounding plug that looks like the plug illustrated in Fig. A. A temporary adapter, which looks
like the adapter illustrated in Fig. B, may be used to connect this plug to a matching 2-conductor
receptacle as
shown in Fig. B if a properly grounded outlet is not available. The temporary
adapter should be used only until
a properly grounded outlet can be installed by a qualified electrician.
The green-colored
rigid ear, lug, and the
like, extending from the adapter must be connected
to a permanent ground such as a properly grounded outlet
box. Whenever the adapter is used, it must be held in place with a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electric Code.
In all cases, make certain that the receptacle in question is properly grounded.
If you are not sure,
have a qualified electrician check the receptacle.
GROUNDED
OUTLET BOX
CURRENT
CARRYING-'_
GROUNDING
BLADE_
IS LONGEST OFTNE3BLADES
Fig. A
GROUNDED OUTLET BOX
-GROUNDING
MEAN
_ADAPTER
Fig. B
Publicidad
