Scheppach HC06 Traduccion Del Manual De Instrucciones Originale página 25

• We recommend that you clean the equipment im-
mediately after you use it.
• Clean the equipment regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plastic
parts in the equipment. Ensure that no water can
get into the interior of the equipment.
• You must disconnect the hose and any spraying
tools from the compressor before cleaning. Do not
clean the compressor with water, solvents or the
like.
10.2 Maintenance of the pressure vessel (fig. 1)
m Important! To ensure a long service life for the
pressure vessel (2), drain off the condensate after
each use by opening the drain screw (1).
Release the vessel pressure first (see 10.4.1).
The drain screw is opened by turning it counter-clock-
wise (when looking at the screw on the bottom of the
compressor) so that the condensate can be complete-
ly drained out of the pressure vessel. Then close the
drain screw again (turn clockwise). Check the pres-
sure vessel for rust and damage each time before use.
The compressor shall not be operated if the pressure
vessel is damaged or rusty.
If you discover damage, please contact the customer
service workshop.
10.3 Safety valve (fig. 2)
The safety valve (17) has been set for the highest per-
mitted pressure of the pressure vessel. It is not permitted
to adjust the safety valve or remove the connection lock
(17.2) between the exhaust nut (17.1) and its cap (17.3).
Actuate the safety valve every 30 operating hours but
at least 3 times a year, to ensure that it works when re-
quired. Turn the perforated exhaust nut (17.1) counter-
clockwise to open it and use your hands to pull the valve
rod outwards over the perforated exhaust nut (17.1) to
open the safety valve outlet. Now, the valve audibly
releases air. Then, tighten the exhaust nut clockwise
again.
10.4 Storage (fig. 3)
m Important!
Disconnect the device from the mains outlet and wind
up the mains cable (14) on the cable holder (4). Vent
the device and all connected compressed air tools.
Store the compressor in such a way that it cannot be
used by unauthorised persons.
m Important!
Store the compressor only in a dry location which is
not accessible to unauthorized persons. Always store
upright, never tilted!
10.4.1 Releasing excess pressure
Release the excess pressure by switching off the com-
pressor and using the compressed air which is still left
in the pressure vessel, e.g. with a compressed air tool
running in idle mode or with a blow-out pistol.
10.5 Transport (fig. 2/4)
The compressor can be transported with the handle
(16). To do so, wind the mains cable (14) onto the ca-
ble holder (4).
10.6 Spare-part ordering
Please quote the following in your order for spare
parts:
• Type of device
• Article No. of deviceIdent. No. of device
• Spare Part No. of the required spare part
10.6.1 Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: coupling
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
11. Disposal and recycling
Notes for packaging
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 25