cecotec Bolero GRANDSOMMELIER 820 COOLCRYSTAL Manual De Instrucciones página 24

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Light
2. Interior wall
3. Shelf
4. Door sealing
5. Legs
6. Drain tray.
7. Upper door hinge
8. Door
9. Lower door hinge
Note:
- The graphics in this manual are schematic representations and may not exactly match the
product.
- To make the most out of the device in terms of energy, place all the shelves and drawers in
their original position, that is, as shown in figure 1.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the product out
of the box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Technical Support Service of Cecotec
immediately.
3. INSTALLATION
- The location you choose for the device must be properly ventilated and far from heat
sources. Do not place the device near heat sources, like a hob, and avoid direct sunlight to
ensure the cooling effect and save on energy. It is not recommended to place the device in
a wet place, as it may rust and cause electrical leakage.
- During operation, the device releases heat into the environment. Therefore, you should
leave at least 100 mm at the rear and sides of the appliance.
46
GRANDSOMMELIER 820/1220 COOLCRYSTAL
- Place the appliance on a solid, flat surface to keep it stable, or vibrations and noises will
occur. Make sure that the appliance is level by adjusting the height with its legs.
- Wait at least 4 hours before plugging the device back to a power supply. Clean the inside
with a soft cloth and lukewarm water. Check that the drain tray is correctly positioned.
4. OPERATION
This appliance has a temperature control on the front. You can adjust the temperature
between 11-18 °C. The internal temperature may be altered by factors such as the location of
the appliance, the ambient temperature, and how frequently the door is opened, etc.
Control panel. Fig. 2
- Light control button
- Temperature unit button
- Temperature indicator
- Temperature increase button
- Temperature decrease button
On
Plug in the device. Set the desired temperature using the temperature increase or decrease
buttons.
Please note
After setting the temperature, the temperature display will show the internal temperature of
the appliance, which will gradually change until the set temperature is reached.
Temperature unit change button
Use the temperature unit button to switch between Fahrenheit and Celsius.
Light on/off
Press the light control button to switch the interior light on or off.
5. STORAGE SUGGESTIONS
- This device intended to be used exclusively for wine preservation.
- The Bolero GrandSommelier 820 CoolCrystal is designed to store a maximum of 8
standard-size bottles, storing 2 bottles per shelf.
- The Bolero GrandSommelier 1220 CoolCrystal is designed to store a maximum of 8
standard-size bottles, storing 2 bottles per shelf.
ENGLISH
47
GRANDSOMMELIER 820/1220 COOLCRYSTAL