Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1.
Upper hinge
2.
Door seal
3.
Shelves
Door handle
4.
5.
Tilted shelf
6.
Adjustable feet
7.
Lower hinge
Note:
-
The graphics in this manual are schematic representations and may not exactly match the
product.
To make the most out of the appliance in terms of energy, place all the shelves in their
-
original position, that is, as shown in Figure 1.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
3. INSTALLATION
-
The location you choose for the appliance must be properly ventilated and far from heat
sources. Do not place the appliance near heat sources, like a hob, and avoid direct sunlight
to ensure proper cooling and save energy. It is not recommended to place the appliance in
a wet place, as it may rust and cause electrical leakage.
-
During operation, the appliance releases heat into the environment. Follow the instructions
below to ensure proper heat dissipation:
B O LE R O G RAN DSOM M ELIER 340 3 0 BLACK/INOX COM PRESSOR
54
o
Leave at least 200 cm
of free space around the appliance.
3
o
Leave at least 20 mm of free space between the wine cooler and the rear wall.
o
Leave at least 50 mm of free space between the sides of the appliance and other walls of
devices.
o
Ensure constant air circulation around the wine cooler.
-
Place the appliance on a solid, flat surface to keep it stable, or vibrations and noises will
occur. Make sure that the appliance is level by adjusting the feet. If possible, do not place
the appliance directly on the ground.
-
Wait at least 2-3 hours before plugging the appliance into a power outlet and storing
bottles inside. Clean the inside with a soft cloth and lukewarm water. Check that the
shelves are correctly positioned.
-
Installation is recommended in a location with an ambient temperature between 16 and
32 °C. A lower or higher temperature than indicated may affect optimal operation of the
appliance.
It is not advisable to use the wine cooler if ambient temperature is below 10 °C.
-
-
A water container can be placed inside the appliance to maintain humidity.
4. OPERATION
This appliance has a temperature control on the front. You can adjust the temperature between
5 and 8 °C (41-64 °F). The internal temperature may be affected by factors such as the location
of the appliance, the ambient temperature, the door opening frequency, etc.
Control panel. Fig. 2
1.
Unlock icon
2.
Temperature Unit Selection and Light On/Off icon
3.
Temperature indicator
Temperature increase icon
4.
5.
Temperature decrease icon
Temperature range displayed on the control panel: 0-37 °C (32-99 °F)
Temperature tolerance
-
°C: if the temperature measured by the probe is within the range +/- 1 °C of the set
temperature, the control panel display will show the value of the set temperature.
°F: if the temperature measured by the probe is within the range +/- 2 °F of the set
-
temperature, the control panel display will show the value of the set temperature.
BOLERO GRAN DSO MMELIER 34030 BLACK/INOX COMPRES SOR
ENGLISH
55
Publicidad
