IKEA LAGAN Manual Del Usuario página 7

button and within 4 seconds close the door: the timer
The start time of the program may be delayed for a period
ENGLISH
will begin counting down.
of time between 1 and 12 hours.
3. Once this time has elapsed, the indicator light «h»
1. Press the DELAY button: the corresponding «h» symbol
switches off and the wash cycle begins.
DELAY
appears on the display; each time you press the button,
To adjust the delay time and select a shorter period of time,
ENGLISH
The start time of the program may be delayed for a period
the time (1h, 2h, etc. up to max. 12h) from the start of
press the DELAY button. To cancel it, press the button
of time between 1 and 12 hours.
the selected wash cycle will be increased.
repeatedly until the selected delayed start indicator light
1. Press the DELAY button: the corresponding «h» symbol
2. Select the wash program, press the START/PAUSE
«h» switches off.
DELAY
appears on the display; each time you press the button,
button and within 4 seconds close the door: the timer
The DELAY function cannot be set once a wash cycle
The start time of the program may be delayed for a period
the time (1h, 2h, etc. up to max. 12h) from the start of will begin counting down.
has been started.
of time between 1 and 12 hours.
Programs table
the selected wash cycle will be increased.
3. Once this time has elapsed, the indicator light «h»
1. Press the DELAY button: the corresponding «h» symbol
2. Select the wash program, press the START/PAUSE
switches off and the wash cycle begins.
appears on the display; each time you press the button,
To adjust the delay time and select a shorter period of time, button and within 4 seconds close the door: the timer
the time (1h, 2h, etc. up to max. 12h) from the start of
will begin counting down.
press the DELAY button. To cancel it, press the button
the selected wash cycle will be increased.
3. Once this time has elapsed, the indicator light «h»
repeatedly until the selected delayed start indicator light
Program
2. Select the wash program, press the START/PAUSE
«h» switches off. switches off and the wash cycle begins.
button and within 4 seconds close the door: the timer
To adjust the delay time and select a shorter period of time,
The DELAY function cannot be set once a wash cycle
will begin counting down.
press the DELAY button. To cancel it, press the button has been started.
3. Once this time has elapsed, the indicator light «h»
repeatedly until the selected delayed start indicator light
Eco switches off and the wash cycle begins.
1 «h» switches off.
1 Eco
The DELAY function cannot be set once a wash cycle To adjust the delay time and select a shorter period of time,
has been started. press the DELAY button. To cancel it, press the button
Conventional
2
repeatedly until the selected delayed start indicator light
wash and dry
«h» switches off.
2 Fast Wash 40'
The DELAY function cannot be set once a wash cycle
Intensive
3
has been started.
Eco
3 Intensive 1
Fast
4
Conventional
2
Sanitizing
5
wash and dry
Eco
1
4 Mixed
Intensive
3
Pre-Wash
6
Conventional
2
wash and dry
Eco
1
5 Glass
Fast
4
Self-Clean
7
Intensive
3
Conventional
2
5 Sanitizing
wash and dry
Fast
4
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2019.
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020.
Intensive
3
Pre-Wash
6 Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following
Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following address:
address: dw_test_support@whirlpool.com
Sanitizing
5
dw_test_support@whirlpool.com
Pre-treatment of the dishes is not needed before any of the programs.
Fast
4
Self-Clean
Pre­treatment of the dishes is not needed before any of the programs. 7
*) Not all options can be used simultaneously.
*) Values given for programes other than the eco program are indicative only. The actual time may vary depending on many factors such as Pre-Wash
6
**) Values given for programes other than the eco program are indicative only. The actual time may vary depending on many
temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional Sanitizing
5
factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of
selected options and sensor calibration.
load, load balancing, additional selected options and sensor calibration.
Self-Clean
7 ECO program data is measured under laboratory conditions according to European Standard EN 60436:2019.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
Pre-Wash
6 Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following
1. ECO - Eco program is suitable to clean normally soiled tableware, that for this use, it is the most efficient program in terms of its combined
address: dw_test_support@whirlpool.com
energy and water consumption, and that it is used to assess compliance with the EU Ecodesign legislation.
PROGRAMS DESCRIPTION
Pre-treatment of the dishes is not needed before any of the programs.
2. FAST WASH 40' - Program for limited quantity of normally soiled crockery. Ensures optimal cleaning performance in shorter time.
Self-Clean
7 ECO program data is measured under laboratory conditions according to European Standard EN 60436:2019.
*) Not all options can be used simultaneously.
3. INTENSIVE - Program recommended for heavily soiled crockery, especially suitable for pans and saucepans (not to be used for delicate
Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following
**) Values given for programes other than the eco program are indicative only. The actual time may vary depending on many
items).
address: dw_test_support@whirlpool.com
factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of
4. MIXED - Mixed soil. For normally soiled dishes with dried food residues.
Pre-treatment of the dishes is not needed before any of the programs.
load, load balancing, additional selected options and sensor calibration.
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2019.
5. GLASS - Program for delicate items, which are more sensitive to high temperatures, for example glasses and cups.
*) Not all options can be used simultaneously.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following
**) Values given for programes other than the eco program are indicative only. The actual time may vary depending on many
address: dw_test_support@whirlpool.com
factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of
PROGRAMS DESCRIPTION
Pre-treatment of the dishes is not needed before any of the programs.
load, load balancing, additional selected options and sensor calibration.
*) Not all options can be used simultaneously.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
**) Values given for programes other than the eco program are indicative only. The actual time may vary depending on many
factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of
PROGRAMS DESCRIPTION
load, load balancing, additional selected options and sensor calibration.
Modifying a running program Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
If a wrong program was selected, it is possible to change it, provided that it has only just begun: open the door, press and hold the ON/OFF
PROGRAMS DESCRIPTION
button, the machine will switch off. Switch the machine back on using the ON/OFF button and select the new wash cycle and any desired
options; Start the wash cycle by pressing START/Pause button and closing the door within 4 sec.
If it takes more than 4 seconds the appliance automatically pauses and you must restart the appliance again by repeating the last operation.
Adding extra crockery
Without switching off the machine, open the door (START/Pause led starts blinking) (be aware of HOT steam!) and place the crockery inside the
dishwasher. Press the START/Pause button and close the door within 4 sec., the cycle will resume from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a power cut, the cycle pauses. Press the START/Pause button and close the door within
4 sec., the cycle will resume from the point at which it was interrupted.
Drying
Program
phase
50°
50°
55°
45° -
Program
65°
50°
65°
Program
-
50°
55°
65°
50°
55°
Program
65°
- -
55°
50°
45°
-
50°
-
65°
65°
55°
65°
-
50°
65°
-
-
65°
-
50°
-
65°
-
-
65°
-
65°
- -
-
65°
To download the full version visit www.ikea.com
added together with the dishwasher. To see how to mount protec-
tion foil please refer to (INSTALLATION GUIDE).
NaturalDry
NaturalDry functionality could be disabled by the user as follows:
1. Go to the Dishwasher software menu pressing and holding
Door opening system NaturalDry is a convection drying system
button (6 sec).
which automatically opens the door during/after drying phase to
2. You switched to NaturalDry Control Menu, you could change
ensure exceptional drying performance every day. Door opens at
NaturalDry
status of NaturalDry functionality by pressing
the temperature that is safe to your kitchen furniture.
E
– enabled
As additional steam protection, special designed protection foil is
Door opening system NaturalDry is a convection drying system
To confirm the change and exit from the Control Menu please
which automatically opens the door during/after drying phase to added together with the dishwasher. To see how to mount protec-
press and hold
tion foil please refer to (INSTALLATION GUIDE).
ensure exceptional drying performance every day. Door opens at
NaturalDry
NaturalDry functionality could be disabled by the user as follows:
the temperature that is safe to your kitchen furniture.
1. Go to the Dishwasher software menu pressing and holding
As additional steam protection, special designed protection foil is
Door opening system NaturalDry is a convection drying system
added together with the dishwasher. To see how to mount protec- button (6 sec).
which automatically opens the door during/after drying phase to
2. You switched to NaturalDry Control Menu, you could change
ensure exceptional drying performance every day. Door opens at tion foil please refer to (INSTALLATION GUIDE).
Duration of
Duration of
status of NaturalDry functionality by pressing
NaturalDry functionality could be disabled by the user as follows:
the temperature that is safe to your kitchen furniture.
E
wash program Available wash pro-
– enabled
1. Go to the Dishwasher software menu pressing and holding
As additional steam protection, special designed protection foil is
To confirm the change and exit from the Control Menu please button (6 sec).
(h:min)*) options added together with the dishwasher. To see how to mount protec-
*)
press and hold
tion foil please refer to (INSTALLATION GUIDE). 2. You switched to NaturalDry Control Menu, you could change
(h:min)
status of NaturalDry functionality by pressing
NaturalDry functionality could be disabled by the user as follows:
E
– enabled
1. Go to the Dishwasher software menu pressing and holding
3:35
To confirm the change and exit from the Control Menu please
button (6 sec).
press and hold 2. You switched to NaturalDry Control Menu, you could change
Duration of
status of NaturalDry functionality by pressing
E
Available wash pro-
– enabled
0:40
To confirm the change and exit from the Control Menu please
options
*)
-
press and hold
(h:min)
Duration of
Available wash pro-
2:40
-
options
*)
(h:min)
Duration of
-
Available wash pro-
2:15
options
*)
-
(h:min)
-
1:40
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
button:
d
– disabled
button (3 sec).
Water
button:
Water
d
consumption consumption
– disabled
consumption consumption
gram (litres/cycle) (kWh/cycle)
(litres/cycle) (kWh/cycle)
button (3 sec).
**)
button:
d
– disabled
2:45 12.0
9.5
button (3 sec).
2:00 15.0 button:
Water
d
– disabled
9.0
consumption consumption
gram
(litres/cycle) (kWh/cycle)
2:30 15.0
button (3 sec).
**)
Water
2:45 12.0
18.0
consumption consumption
0:55 11.5
gram
(litres/cycle) (kWh/cycle)
**)
2:00 15.0
Water
1:40 11.5
2:45 12.0
16.0
consumption consumption
gram
(litres/cycle) (kWh/cycle)
2:30 15.0
0:10 **) 4.5
2:00 15.0
2:45 12.0
11.5
0:55 11.5
0:50 8.0
2:30 15.0
2:00 15.0
1:40 11.5
0:55 11.5
2:30 15.0
0:10 4.5
1:40 11.5
0:55 11.5
0:50 8.0
0:10 4.5
1:40 11.5
0:50 8.0
0:10 4.5
0:50 8.0
9
7
Energy
Energy
0.92
0.95
1.35
Energy
0.50
1.50
Energy
0.92
1.60
1.10
1.35
Energy
1.30
0.92
1.40
1.50
0.01
1.35
0.92
1.20
1.10
0.80
1.50
1.35
1.30
1.10
1.50
0.01
1.30
1.10
0.80
0.01
1.30
0.80
0.01
0.80