Marantz DD-82 Guia Del Usuario página 5

FOREWORD
This section must be read carefully before any connection is
made to the mains supply.
EQUIPMENT MAINS WORKING
SETTING
Your Marantz product complies with the household power and
safety requirements in your area.
"/02" Version product can be powered by 230 V AC only.
"/05" or "/07" Version product can be powered by 240 VAC only.
This is a voltage selector (2-position or 4-position) on the rear
panel of the "/01" Version product,. Be sure to set the voltage
selector to the mains voltage of your area before using the unit.
IMPORTANT:
This apparatus is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3A, A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place.
If the mains piug contains a fuse, this should have a value of 3A.
lf a plug without a fuse is used, the fuse at the distribution board
should not be greater than 5A.
NOTE: The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13A socket
elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accordance with the
following code:
BLUE~"NEUTRAL" ("N")
BROWN-—"LIVE" ("L")
1. The BLUE wire must be connected to the terminal which is
marked with the letter "N" or coloured BLACK.
2. The BROWN wire must be connected to the terminal which
is marked with the letter "L" or coloured RED.
3. Do not connect either wires to the earth terminal in the plug
which is marked by the letter "E" or by the safety earth
symbol + or coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead — not simply over the two
wires.
COPYRIGHT
- Copyright Act 1956
~ Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963, and 1972
~ Any subsequent statutory enactments and orders
PRECAUTIONS
GENERAL PRECAUTIONS
When installing the equipment ensure that:
— the ventilation holes are not covered.
~ itis placed on a vibration-free surface.
— it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.