While charging, the display shows the
estimated battery charge percentage.
Touching the key
you can scroll through:
- Ampere hour (Ah) stored by the battery
since the start of the current charge.
-
Battery voltage
- Actual charging current (A)
- Estimated charge percentage.
If you want to stop charging before its normal end, you must put the charger
in STOP state before disconnecting the battery to do not damage electrical
contacts of the connector.
To put the charger in STOP state, hold down
The display will show word STOP and you can safely disconnect the battery
from the charger.
After reaching the end of charge, the display
will indicate 100%
depending on the end of charge setting
(Equalize or Floating), it will show different
communicates.
e
Once the charger enters the Equalize or Floating stage,
the battery is charged and can be disconnected from the charger.
End of charge Equalize: The display will show Equ Run which means that
the charge stage has entered the equalization phase.
Once the equalization phase is finished, the display will show Equ End
( ee fig.
S
B
page 6)
End of charge Floating: The display will show Floating.
The charger has entered the maintenance mode and as long as it is
connected to the battery it will prevent the battery from self-discharge.
It is possible to disconnect the battery at any time during the Floating phase
( ee fig.
S
B
page 6)
during charging,
(V)
.
of
charge, and then,
.
.
10.24.42
80%
10.24.42
614
10.24.42
51.7 V
for 3 seconds.
10.24.42
100%
Ah
24.