Hoover SteamVac Manual Del Propietário página 12

BELTOR BRUSHROLL:
H ow to Remove and Replace
,& WARNING ,&
To reduce the risk of injury from moving parts -
unplug cleaner before changing belt.
How to Remove
3.1 Flip cleaner on its side to expose nozzle base.
3.2 To remove belt cover, use Phillips screwdriver
to remove the two screws. Arrows show location of
screws.
3.3 Grasp belt cover near brushroll and lift out.
3.4 Grasp brushroll with one hand, using other
hand to keep tension on belt when removing. Lift up
when pulling out.
How to Replace
3.5 Remove belt. Dispose of old belt.
3.6 Place belt on motor shaft, then slip brushroll
through belt. Place belt in area of brushroll without
bristles.
3.7 With belt in place, pull and slide brushroll into
nozzle, making sure that the brushroll end caps are
in the correct orientation (Diagram A).
3.8 Replace belt cover by inserting end furthest
from brushroll first. Then place front of belt cover
into position. Secure by replacing the two screws.
• IMPORTANT •
Rotate brushroll manually to make sure belt is
not twisted or pinched.
12