Hoover SteamVac Manual Del Propietário página 6

TOOLCADDYASSEMBLY
B
1.4 Align tabs on tool caddy with slots on midsection
and snap into place.
1.5 Place nut into recess on tool caddy and hold
into place (Diagram A). Press handle release with
your other hand to tilt the midsection backwards
(Diagram B).
1.6 Place screw through center of lower midsection
and tighten.
1.7 Wrap the cord around the upper and lower
cord clips.
1.8 Slide the Upholstery/Stair Attachment into the
middle slot of the lower tool caddy.
1.9 Clip the adapter end of the hose into the slot on
the lower tool caddy.
1.10 Run the hose to the upper caddy and press
into hose clip #1 (See Fig. 1.7).
1.11 Continue wrapping the hose clockwise around
the tool caddies, pressing the hose into the groove
on the bottom of the lower tool caddy.
1.12 Run the hose back to the upper caddy and
press into hose clip #2 (See Fig. 1.7).
1.13 Lock the attachment end of the hose into place
by pressing down onto the post located on the right
side of the lower tool caddy, until secure in place.
/