Publicidad
Idiomas disponibles
Idiomas disponibles
EN Functions & Settings
Before you start
1. Verify that the rated current of the power socket is in line with the technical data (table on previous
pages), and is equipped with a grounding system.
01 Work/Standby
Plug in the power, a buzzer will "beep" one time.
Press the power key "
standby state.
02 Power selection
Press "
" key to switch between different powers such as high power ( - - - ) medium power ( - - ) and low
power ( - ) .
03 Temperature Setting
Under the working status, press " + " or " - " key to adjust the temperature (7-35°C). Press and hold the keys
to quickly set the temperature.
With non-operation for 5 seconds, temperature will be validated and it will exit the temperature setting screen.
04 Timer ON
In standby mode, Press the timer key "
Press " + " or " - " key to set the time (1-24h). With non-operation for 5 seconds, set time will be validated.
Appliance will start after x hours (1-24h) according to selected time.
Dash light remains on, on the top of the timer key, until it starts
Once programming is started, press the timer key "
Press the key twice to set again.
Programming is cancelled in case of power failure or if power key "
05 Timer OFF
In working status, Press the timer key "
Press " + " or " - "key to set the time (1-24h). With non-operation for 5 seconds, set time will be validated.
Appliance will shut off after x hours (1-24h) according to selected time.
When the set value is 0h,the programming is cancelled.
06 Memory function
After restarting , the appliance will operate according to the last status before shut down
07 Safety protection function
If the ambient temperature exceeds 50°C under the standby or working state, all outputs are turned off.
The buzzer emits 10 long beeps, the digital screen displays "FF" and flashes for 75 seconds.
Even if the ambient temperature is less than 50°C, the running or operation can not be resumed.
The operation can only be done after the power is turned OFF and ON again.
5059340471648_MNL_IN_V06.indb 35
5059340471648_MNL_IN_V06.indb 35
" to enter the heating working state, or press the power key "
" to enter timer ON setting screen.
" to enter timer OFF setting screen.
" to check the remaining time.
" is pressed
35
" to enter the
27/6/2022 11:19 AM
27/6/2022 11:19 AM
Publicidad
