Publicidad
Idiomas disponibles
Idiomas disponibles
B5.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
Rotate blower unit counterclockwise 180°.
4
Before Rotation
Back of
Microwave
5
Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting
Wires Routed Through Right Side
Roll the blower unit 90° so that fan blade
6
openings are facing out the back of the
microwave.
Before Rolling
Back of
Microwave
Remove the knockout plates in the back of the unit
7
with snips. (For some models)
Back of mircrowave
Installation Instructions
After Rotation
Back of
Microwave
After Rerouting
Wires Routed Through Left Side
After Rolling
Back of
Microwave
Knockout Plates:
Snip all 4 tabs on
each knockout panel
and remove the metal
knockouts for rear airflow.
Please take care to
remove any sharp edges
created from removing
the knockout plates.
8
Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
NOTE: The blower unit exhaust
openings should match exhaust
openings on rear of microwave oven.
Secure the blower unit to the microwave with
9
the original screws.
10
Replace the blower plate in the same position
as before with the screws
11
Attach the exhaust adaptor to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Guide
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
EN-18
Blower Plate
Back of
Microwave
Blower Motor
Screw
is tight.
Adaptor
Locking Tabs
End A
Back of
Microwave
Guide
Publicidad
