Descargar Imprimir esta página

Sharp SMO1752JS Manual De Installación E Instrucciones Para El Uso página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

C4.
MOUNT THE MICROWAVE
OVEN (cont.)
Insert 2nd self aligning
5
screw through remaining
top cabinet hole.
Turn two full turns on screw.
7
Tighten the two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
8
Install grease filters. See the Use & & & & a nd Care
packed with the microwave.
C5. INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
NOTE: The charcoal filter is factory installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
Some models have a filter access door.
Refer to the Use and Care to see if yours does.
For models without the recirculation filter access
door,follow these steps to replace or install a charcoal
filter.
1
Unplug microwave oven or disconnect power.
Installation Instructions
EN-22
2
Open the microwave door and remove the two
vent cover mounting screws located on top of the
microwave using a #2 Phillips screwdriver.
Remove the vent cover by pulling it out at the top
and then pulling out.
3
Remove the charcoal filter by pushing the
top of the filter inwards,then pull it forward
out from the unit.
4
Slide the top of the new charcoal filter into the
top of the filter cavity.
;
Charcoal
Filter

Publicidad

loading