Beaba N6T Manual página 17

Initial
Bottle type
temperature
Fridge
Glass
Room
Fridge
Plastic
Room
* These recommendations are based on the test with the use of the BEABA wide-
neck glass bottle and the 2-in-1 training plastic bottle.
Note :
- Heating time varies with different brands of bottles and materials. The volume
of milk/water to be heated has also a significant impact. If the bottle is not hot
enough, put it back in the appliance and restart the Steam Fast mode to heat
again for few minutes.
- After preparation, the bottle should be consume within 30 min. Discard any
unfinished baby bottle, and do not reheat a second time.
BABY JAR MODE
The Baby Jar mode is for heating gradually the baby food.
1. Pour water into the bottle warmer (level max).
2. Place the baby food container and lift-out basket into the bottle warmer.
Note : for small capacity baby jars, put the container first et then add water
3. Press the ON/OFF button.
4. Press the Baby Jar mode button.
5. When the time indicator flashes, press the setting button +/- to choose the
working time (1-59 mins). The default time is 30 mins.
6. The bottle warmer will start working after the temp/time indicator flashes
twice. The Babyjar mode button keeps flashing.
BE CAREFUL, RISK OF BURNING
to make sure that it is heated evenly.
7. The bottle warmer will beep 5 times at the end of countdown.
Always check that the temperature of the baby food is not too high and that
there is no risk of burning your child.
Volume of milk or water
60 ml 120 ml
2 min 3 min
1,5 min 2,5 min
3,5 min 4 min
2,5 min 3 min
During the heating, stir the baby food
17
180 ml 240 ml
3,5 min 4,5 min
3 min 3,5 min
5 min 5 min
3,5 min 4 min