Chicco activ3 Manual Del Usuario página 11

a substitute for a cot.
• Air the carry cot after prolonged use.
• Before lifting or transporting the
carry cot, the base needs to be
adjusted to the lowest position.
• In the carry cot your child's head
must never be lower than their
body.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance.
Cleaning and maintenance should only be carried out by
an adult.
CLEANING
Clean all fabric parts with a damp sponge and neutral
detergent. Please refer to the care labels for instructions on how
to clean the fabric parts. Periodically wipe the plastic parts clean
with a soft damp cloth. To prevent the formation of rust, always
dry metal parts if they have come into contact with water.
WASHING
The hood, the internal lining of the carry cot, and the
mattress covering are removable and washable; it is advised
to carefully follow the washing instructions shown on the
item's label.
1. Remove the hood from the carry cot following the
instructions in point 3; then open the snap buttons that
anchor the metal arch to the fabric, and remove only the
metal arch, pulling it from one of the two ends (fig. 9); do
not remove the rear arch with the 4 pins for the washing
operations.
2. Use the opening located on the rear of the cover to
remove the mattress padding (fig. 10).
3. To remove the inner lining of the carry cot, pull out the
plastic band located near the head of the carry cot, open
the two snap buttons on the sides, the velcro, and the two
"tabs" found at the foot of the carry cot (fig. 11).
The washing symbols and relative meanings are indicated
below:
Hand wash
30° C
Do not bleach
C
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE
If necessary, lubricate with dry silicone lubricant. Dry metal
parts to prevent the formation of rust. Do not submerge in
water. Periodically clean plastic parts with a damp cloth. To
avoid friction, ensure that the locking devices of the carry
cot and pram are free from dust and sand. Do not leave the
product exposed to the sun for a long period of time; the
fabrics may discolour.
ATTACHING AND REMOVING THE CARRY COT
4. Check that the clips on the end of the metal arch are
hooked to the buttons located on the fabric section. If the
buttons are secured correctly, the two ends of the metal
arch will be clearly visible (fig 1).
5. Insert the two metal parts in the appropriate supports (B
and C) located in the central part of the carry cot until a
click is heard indicating that they have locked into position
correctly (Fig. 2 A); then fix the 4 pins of the rear arch (Fig.
2 B).
Note: The connection system is set inside plastic supports
B and C, the round button on the support only serves to
release the hood (see point 3).
6. To remove the hood, first extract the 4 pins of the rear arch
(Fig. 3A) and then release the front arch, pressing the two
buttons located on the base of the locking device (Fig. 3B).
WARNING: Unlocking the hood incorrectly may cause pins
to break.
USING THE HOOD
The carry cot is equipped with a sun canopy and windshield
that can be adjusted to various positions.
7. Inside the hood, between the visor and the first section,
there is a fabric ring from which you can hang soft toys,
with convenient hooks (Fig. 4 A).
To ensure proper ventilation, the hood features an adjustable
rear opening; use the zip fastener to open the fabric flap and
fold it onto the upper part of the hood (Fig. 4B).
INTERNAL COVERING AND COVER
8. To fasten the inner lining of the carry cot: insert the plastic
band located at the head of the carry cot, between the
polystyrene support and the body of the carry cot; next
fasten the two "tabs" at the foot of the carry cot, under the
edge of the carry cot, as shown in figure 5A. The cover
is easily fastened using the zip fastener and connecting
the lateral clips on the fabric to the hood (Fig. 5B). Once
assembled it can be opened from either side.
ADJUSTABLE BACKREST -
COMFORT SYSTEM
9. The carry cot backrest can be adjusted gradually. To
incline or recline the backrest, use the wheel located on
the outer part of the carry cot near the baby's feet (Fig. 6).
WARNING: • It is recommended to air the carry cot in case
it has been used for a long time.
CARRYING HANDLE
10. The carry cot features a comfortable carry handle that
can be adjusted in three positions (fig. 7):
A) Transport
B) Middle
C) Rest
11. To put the handle in the vertical position, grasp it in the
centre and pull up until you hear a click (Fig. 8A); to put
the handle back in the rest position, press both buttons
at the base of the handle at the same time and then turn
it downwards (Fig. 8B).
WARNING: Do not transport the carry cot with the handle
11