Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL PANEL
ON / OFF
1 cup
INSTALLATION
Installation instructions
When installing the device, follow the safety instructions below:
•
Do not place the device near water taps or sinks. Water entering the espresso
machine can cause damage.
•
Do not place the device in a room where the temperature can drop below
freezing. The device may be damaged if the water it contains freezes.
•
Lay the mains cable in such a way that it cannot be damaged by sharp edges
or come into contact with hot surfaces (e.g. electric hotplates).
•
The device emits heat. After placing the device on the worktop, leave a gap of
at least 3 cm between the device surfaces and the side and rear walls and at
least 15 cm above the device.
•
Clean all detachable parts with clear water.
Connecting the device
•
Make sure that the mains voltage corresponds to the voltage specified on
the rating plate on the bottom of the device. Plug the device into a properly
grounded and properly installed outlet. If the outlet does not match the device
plug, have a qualified professional replace the outlet with an appropriate type.
2 cups
Steam
ON / OFF
STEAM /
HOT
WATER
STEAM
DIAL
EN
27
Publicidad
