cecotec WANDERLUSTMIX USB Manual De Instrucciones página 37

stop automatically.
2. When charging the battery with the USB cable, the indicator light will remain red until
the unit is fully charged. Once charging is complete, the indicator light will turn white.
3. The red indicator light will flash five times if you try to use the blender without the cup or
if you have inserted it incorrectly, indicating that it cannot work.
4. When charging, if you try to use the blender, the red indicator light will flash indicating
that the device cannot operate.
5. When the blender stops due to abnormal food rotation, the red and white indicator light
will flash ten times alternately.
6. The red indicator light will remain on for five seconds when the blender is almost out of
battery, or the battery is completely used up.
7. If the cup leaks liquid, the appliance stops automatically as a protection measure after 5
seconds of operation. In that moment, the red indicator light will flash three times.
Tips
- Turn the cup upside down if you see that the liquid is spilling or the thread is too loose. If
you still cannot solve the problem, please contact the official Cecotec Technical Support
Service.
- The recommended charging time is from 3 to 5 hours.
- It is recommended to use 200 ml of water or any other liquid per 100 g of ingredients.
Operating instructions
1. Cut fruits into small pieces (from 1.5 to 2 cm approx.), peeled and pitted.
2. Add the fruits and water/milk to the cup.
3. Press the power button twice so that the blender starts operating.
4. After 45 seconds, the blender will automatically stop.
Charging process
- The battery capacity is 2500 mAhx2. It can be charged by connecting the USB cable to an
adapter (≤2A), external battery, computer, or USB car charger.
1. Plug the USB cable into the charging port on the base.
2. Connect the other end of the cable to an adapter, external battery, USB port on a
computer, etc.
Attention
If the red indicator light is on, the blender is charging. When fully charged, the indicator light
will turn white. Do not use the blender while being charged.
Tips
If you have put the blender on charge, but the light does not work or the battery is not
charging, try changing the charging cable. If it still does not work, contact the official Cecotec
Technical Support Service to solve the problem.
BATIDORA DE VASO INDIVIDUAL USB / USB SINGLE-SERVE JUG BLENDER
ENGLISH
37