Testing Function; Safety Features - Phocos CIS -N-MPPT-LED 85/15 Manual Del Usuario

Testing Function

Pushing the test button on the CIS-CU (Control Unit) will switch on load terminal for 1 minute.
Should pressing the button cause a load disconnect event (LVD/SOC, overcurrent) then the load will be switched off immediately.

Safety Features

Reverse polarity
Short circuit (4)
Overcurrent
Reverse current
Overvoltage
Undervoltage
Over temperature
(1) Panels are short circuited by diodes. The controller can therefore only be subjected to these conditions for a limited time. A battery connected to the
panel terminals in reverse polarity will instantly cause a damage to the controller.
(2) A battery fuse is necessary to protect the CIS-N-MPPT-LED 85/15 from getting damaged by reverse polarity connection on the battery terminals.
(3) Controller can protect itself, but any connected loads might be damaged.
(4) Short circuit: >3x – 20x nominal current.
(5) Battery must be protected by a fuse, or it might be permanently damaged in case of short circuit.
(6) MPPT switches off when detecting reverse current.
(7) At voltages above 85 V the MPPT will stop charging.
WARNING: The combination of different error conditions may cause damage to the controller. Always remove the fault condition before you continue
connecting the controller!
www.phocos.com
PV terminal
Protected (1)
Protected
Limited
Protected (6)
Max. 85 V (7)
---
Reduces the charging current if over temperature occurs and switches off the load if the temperature reaches a
high level.
Battery terminal
Not protected (2)
Protected (5)
---
---
Max. 50 V
---
LED output
Protected (3)
Not protected
---
---
Switches off above 15.5/31.0 V
Switches off
2 2 | P a g e