FAR RAC 230 Instrucciones De Uso página 15

RAC 230
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2)
After the clamping, the sheared nail is piped by the riveting tool,
ejected from the back and let fall down by the nail deviator (A).
By swinging the valve (B) you can adjust the suction power.
By the suction nail system, the rivet remains in the nozzle also
turning over the head of the riveting tool downwards: this detail
increases a lot the usefulness of the riveting tool. do not keep
the rivet with your fingers!
WARNING!! do not remove the nail deviator (A)
during the riveting operation, as the nail ejection
from the back of the tool can cause damages
to the worker or to persons who are nearby the
work surface.
DO NOT DISPERSE ANY NAIL!
f1
Revisione - 10
GB
In case you want to convey the pieces of sheared nails inside
a container, pull out the baffle (A) and the relative reduction
(B) from the tool.
Connect the riveter with a pipe ø 10 x 8 (C) by inserting it on
the fitting.
CAUTION: the radius of curvature of the pipe must not be less
than 300 mm, as shown in pic. f2.
f2
Date 11-2015 15