Publicidad
For your own protection, read these instructions before using. It is the responsibility of
the user to understand the limitations, proper use, care and maintenance of the product.
Failure to read these instructions could result in serious injury, including blindness.
This manual is to be removed by the wearer only. Failure to read and follow these instructions and warnings
could result in serious injury, including blindness.
Note: Some materials, which may come into contact with the wearer's skin, could cause allergic reactions in susceptible
individuals. Contact Surewerx for information. Check with your supervisor to determine whether this face shield and
window offers the proper protection for the application. Refer to ANSI Z87.1 or CSA Z94.3 for proper application. Face
shields offer limited eye and face protection against common impact hazards, metal chips, particles and sparks. They
will not provide extraordinary protection against severe impact hazards such as, but not limited to, fragmenting grinding
wheels, high speed projectiles, explosive devices, molten metal or hazardous fluids. Impact resistant windows are NOT
unbreakable or impenetrable. Certain Surewerx windows do not meet ANSI Z87.1+ high impact standards and should
only be used for basic impact protection as defined by ANSI Z87.1. This product should not be used for protection in
any sport related activity or simulated war games. Use the proper IR shaded window when exposed to harmful levels
of optical radiation, including burning and cutting. A face shield will not provide any protection against infra-red or
ultraviolet radiation unless the window is marked with a shade numeral per ANSI Z87.1, CSA Z94.3 and EN 166. Do not
use for Arc Welding. Not suitable for protection against X-rays, gamma rays, high energy particulate radiation or lasers.
Inspect face shield and windows frequently and immediately replace if dull, pitted, scratched or damaged. Chemical
contact can cause rapid degradation which severely reduces impact protection. Do not use face shield until a secure fit
has been obtained every time. Primary eye protection, as defined by ANSI Z87.1 and CSA Z94.3, must be worn whenever
using this product. Do not modify in any way. Clean with mild soap and water or pat with clean soft tissue. NEVER
use solvents or abrasive cleaning compounds. Store in a cool, dry location. We recommend you to use the product
for a period of 10 years. The duration of use depends on various factors such as way of use, cleaning, storage and
maintenance. Frequent inspections and replacement in case of damage are recommended.
1.
Inspect the faceshield Window frequently and immediately replace worn, pitted, or scratched Window.
2.
If used with CLEAR Window, this Window will NOT provide any protection against ultraviolet or infrared radiation.
3.
If used with SHADED Window, DO NOT USE FOR ARC WELDING!
4.
This product does NOT conform to ANSI Z87.1 for welding helmets.
5.
A Window must be used at all times.
6.
Product needs to be used only with appropriate Jackson branded Window and headgear.
Window Removal and Replacement
Window Removal
1.
To remove the window, carefully release the window from the bottom (2) chin guard tabs using both
hands. The window should be released towards the inside of the face shield as per image (2). Be
cautious not to apply excess force that may break the frame of the face shield.
2.
Pull on the side frame of the face shield to release the window from the (3) inner tabs on the inside of
the face shield frame. Repeat for the other side of the face shield. Be cautious not to apply excess force
that may break the frame or tabs of the face shield.
3.
Once the bottom and sides of the window are free from the face shield frame, press the tab located on
the crown of the face shield. Lift the bottom of the window upwards. The window should be released
from the top corners and can now be replaced.
PULL
PULL
WARNING!
Inside of the face shield
PULL
PULL
29
Press Release Tab to
release window
Lift the bottom of
window upwards
Publicidad
