Publicidad
Idiomas disponibles
Idiomas disponibles
LED indicators on the control panel
The LED indicators on the control panel show the state
of charge of the battery and if there are problems with
the product.
1
4
3
LED
Indication
indica-
tor
The indicator
flashes.
1
The indicator is
on.
The indicator
flashes.
2
The indicator is
on.
All 4 indicators
3
flash.
Indicator no. 2
2 and
and the first
3
LED on indica-
tor no. 3 flash.
Indicator no. 2
2 and
flashes and in-
4
dicator no. 4 is
on.
30
2
Cause
The X-Halt function is engaged.
Servicing is necessary.
There is a battery error.
Temporary error
The power trigger and the On/Off
button are pushed at the same
time.
Servicing is necessary.
The product does a Firmware
Over-the-Air (FOTA) update.
Servicing necessary.
The battery level is low.
Temperature deviation.
Solution
Wait for the product to cool down and the X-Halt
function to disengage.
Speak to an approved Husqvarna service center.
Pull the power trigger 1 time to reset the error warn-
ing. If the error warning comes back, do a test with a
different battery.
Pull the power trigger 1 time to reset the error warn-
ing. If the problem does not disappear, speak to an
approved Husqvarna service center.
Release the power trigger and start the product.
Speak to an approved Husqvarna service center.
Let the FOTA update finish.
Speak to an approved Husqvarna service center.
Charge the battery.
The product is too hot or too cold.
1960 - 002 - 25.08.2023
Publicidad
