Makita UB402MP Manual De Instrucciones Original página 9

4. To prevent dust irritation the wearing of a face
mask is recommended.
5. While operating the machine, always wear
non-slip and protective footwear. Non-skid,
closed-toed safety boots and shoes will reduce the
risk of injury.
6. Wear ear protection, such as ear muffs.
Exposure to noise can cause hearing loss.
Operation
1. Clear the area of children, bystanders, and
pets. At a minimum, keep all children, bystand-
ers, and pets outside a 15 m radius; outside
the 15 m zone, there is still a risk of injury
from thrown objects. Bystanders should be
encouraged to wear eye protection. If you are
approached, stop the machine.
► Fig.1
2. Switch off the blower and remove the battery
cartridge, and make sure that all moving parts
have come to a complete stop
whenever you leave the blower.
•
• before clearing blockages.
• before checking, cleaning or working on
the blower.
• if the blower starts to vibrate abnormally.
3. Operate the blower only in daylight or in good
artificial light.
4. Do not overreach and keep proper balance and
footing at all times.
5. Always be sure of your footing on slopes.
Walk, never run.
6.
7. Keep all cooling air inlets clear of debris.
8. Never blow debris in the direction of
bystanders.
9. Operate the blower in a recommended position
and on a firm surface.
10. Do not operate the blower at high places.
11. Never point the nozzle at anyone in the vicinity
when using the blower.
12. Never block suction inlet and/or blower outlet.
Be careful not to block suction inlet or
•
blower outlet with dust or dirt when oper-
ating in dusty area.
Do not use nozzles other than the nozzles
•
provided by Makita.
• Do not use the blower to inflate balls,
rubber boat or the similar.
13. Do not operate the blower near open window,
etc.
14. Operating the blower only at reasonable hours
is recommended - not early in the morning or
late at night when people might be disturbed.
15. Using rakes and brooms to loosen debris
before blowing is recommended.
16. Before blowing, slightly dampen surfaces in
dusty conditions or use water mist sprayer if
necessary.
17. Adjust the length of the blower nozzle so that
the air stream can work close to the ground.
18. If the blower strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the blower
to stop it. Remove the battery cartridge, and
inspect the blower for damage before restart-
ing and operating the blower. If the blower
is damaged, ask Makita Authorized Service
Centers for repair.
19. Do not insert fingers or other objects into
suction inlet or blower outlet.
20. Prevent unintentional starting. Ensure the
switch is in the off-position before inserting
battery cartridge, picking up or carrying the
blower. Carrying the blower with your finger
on the switch or energizing the blower that has
the switch on invites accidents.
21. Never blow dangerous materials, such as
nails, fragments of glass, or blades.
22. Do not operate the blower near flammable
materials.
23. Avoid operating the blower for a long time in
low temperature environment.
24. Before assembling or adjusting the machine,
switch off the motor and remove the battery
cartridge.
25. Wear the personal protective equipments
before starting the motor.
26. Before starting the motor, inspect the machine
for damages, loose screws/nuts or improper
assembly. Check all control levers and
switches for easy action. Clean and dry the
handles.
27. Never attempt to start the motor if the machine
is damaged or not fully assembled.
28. Adjust the shoulder harness and hand grip to
suit the operator's body size.
29. During operation, use the shoulder harness.
Keep the machine on your right side firmly.
► Fig.2
30. Hold the front handle with the left hand and the
rear grip with the right hand, no matter you are
right-hander or left-hander. Wrap your fingers
and thumbs around the handles.
31. Never attempt to operate the machine with one
hand. Loss of control may result in an injury.
32. If the machine gets heavy impact or fall, check
the condition before continuing work. Check
the controls and safety devices for malfunc-
tion. If there is any damage or doubt, ask our
authorized service center for the inspection
and repair.
33. Follow the instruction manual of the power
unit for proper use of the power unit.
34. Refer to the instruction manual of the power
unit for how to start and control the machine.
35. During operation, never stand on an unstable
or slippery surface or a steep slope. During
the cold season, beware of ice and snow and
always ensure secure footing.
36. Do not use the machine in bad weather where
visibility is limited. Failure to do so may cause
fall or incorrect operation due to low visibility.
37. Do not use the machine when there is a risk of
lightning.
9 ENGLISH