Sinbo SK 2393B Instrucciones De Uso página 7

ENGLISH
SINBO SK 2393, SK 2393B ELECTRIC KETTLE
INSTRUCTION MANUAL
READ ALL THE INSTRUCTIONS BEFORE USING
IMPORTANT SAFEGUARDS
When using electrical appliance, basic safety precautions should always be followed, including the
following:
1. To protect against electrical hazards do not immerse the mains plug, power base, or kettle in water
or any other liquid. Do not use in the bathroom or near any source of water. Do not use outdoors.
2. Do not touch hot surfaces. Use handles or knobs.
3. Do not open the lid while the water is boiling.
4. Take care when pouring pour slowly, and do not overfill the kettle.
5. Water can remain hot for a considerable time after boiling and can present a scald hazard. Keep the
kettle, the power base, and the mains lead away from the edge of worktops and out of the reach of
children.
6. Do not allow the mains lead to hang over the edge ot the table or worktop, or any where it may be
accidentally caught or tripped over.
7. Close supervision is necessary when any appliance is used near children.
8. Unplug the power base from the wall socket when not in use, before repositioning and before cleaning.
Allow the kettle to cool down fully before cleaning and before storing away.
9. Ensure that the lid is closed before switching the kettle on, otherwise it may not switch off.
10. Check that the kettle is properly located on the power base before switching it on.
11. Do not switch on unless the kettle contains at least 1 cupful of water, otherwise you may damage
it.
12. Do not fill above the bottom of the max mark on the water level indicator (1.7 Liter)
13. Remove the kettle from its power base before filling or pouring.
14. Do not place the kettle, power base or mains lead on or near any hot surface, hotplate, hot hob or
burner.
15. Do not use the kettle for any purpose other than heating water.
16. Use the kettle only with power base supplied (and vice versa)
17. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions. Or
has been damaged in an manner. If the mains lead is damaged, it must be replaced be a special lead
available from the Service department
18. Ensure that the lid is closed before switch
WARNING: The kettle must be used with the base.
WARNING: Do not remove the lid while the water is boiling.
PARTS DESCRIPTION
1. Spout
2. Hinged Lid
3. Push Button of Lid
4. Handle
5. ON/OFF Switch
6. Water level Indicator
7. Cordless Power Base
8. Power Indicator
9. Power Cord
BEFORE USE
Remove all packaging from the kettle and its power base. Before using the kettle for the first time, or
if it has been out of use for a long time, fill to the max mark and boil, then discard the boiled water and
rinse the kettle out with cold water.
- 6 -