Publicidad
Idiomas disponibles
Idiomas disponibles
- Parts Detail -
Cushion with cover
Operations manual
Inflation pump
- Product Specifications -
Materials
Cushion - Flame retardant PVC film (made without DEHP).
Inflation valve - nickel-plated brass
Standard cover - two-way stretch top, spacer mesh fabric sides, non-skid bottom, with
a zipper located in the back of the cover.
Incontinent two-way stretch, fluid-resistant top and sides; non-skid bottom, with a
zipper located in the front of the cover.
- Instructions for Use -
Before you set up your cushion, please carefully read instructions to properly adjust
your Axiom Air LTE cushion. Follow a regular routine of examining and adjusting your
Axiom Air LTE cushion to ensure proper inflation. Daily checks are recommended.
1. Initial inflation of the cushion
a. Slide the inflation pump hose over the inflation valve. Open the inflation
valve counterclockwise.
b. Inflate the cushion.
c. Close the inflation valve clockwise and remove inflation pump from valve.
2. Place the cushion on the chair with air cells facing up and the inflation
valve facing front.
3. The individual should sit in the chair in their normal sitting position. The
cushion should be centered beneath the individual.
4. Open the inflation valve (counterclockwise) to add or decrease air as
needed to conform to your comfort level.
5. Close the inflation valve (clockwise).
6. Ensure there is at least 1-inch of air supporting the individual's lowest bony
prominence. It is important to immerse into the cushion without resting on
the base or bottom of the cushion.
- Troubleshooting -
Not Holding Air
• Inspect the inflation valve and valve boot for damage. Confirm the inflation valve is
completely closed by turning clockwise.
• Visibly check to see if there are any holes. If no holes are visible, immerse cushion
(with valve tightly closed) in sink or tub of water and look for air bubbles.
- If large holes or other leaks are found, see warranty section.
Publicidad
