Toro 51993 Manual Del Operador página 21

Maintenance
Emissions Maintenance Schedule
Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-
road engine repair establishment or individual.
Emission Part
Fuel Tank Assembly (Includes Fuel
Lines, Fuel Cap, and Fuel Filter)
Air Filter
Spark Arrester
Spark Plug
WARNING:
Use only Toro replacement parts when servicing
this product. Use of any other parts may create a
hazard or cause product damage.
Cleaning the Product
 Stop the product before cleaning.
 Clean the exterior of the product with a damp cloth.
 Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
 Wipe or scrape the trimmer head and spool area when
they accumulate dirt or clippings.
 Scrape debris away from air intake vents on both sides of
the motor housing.
CAUTION:
Keeping air intake vents free of grass and debris
prevents motor overheating and possible failure.
Note: Depending on the type of fuel used, the type and
amount of oil used, and/or your operating conditions,
the exhaust port and muffler may become blocked with
carbon deposits. If you notice a power loss with your
gas powered tool, you may need to remove these depos-
its to restore performance. We highly recommended that
only qualified service technicians perform this service.
Servicing the Product
 Check and tighten all fasteners. If any part is damaged or
lost, repair it or replace it.
Maintenance
Inspect before Clean every
each use 5 hours
X
Replacing the Cutting Line
See Figures 19 and 20.
Use of line other than the proper monofilament
cutting line could cause personal injury.
To replace the cutting line.
1. Stop the trimmer.
Make sure the trimmer head stops rotating.
Contact with a rotating trimmer head could
cause personal injury.
2. Remove the spark plug boot. See Figure 23.
3. Remove the retaining cap.
4. Remove the empty spool.
5. Clean the trimmer head thoroughly. Inspect the trimmer
6. Hold the spool with the spring positioned upward.
7. Insert the end of the new line into the hole in the upper
8. Wind the line around the spool as indicated by the ar-
9. Secure the line temporarily by pushing it into one of the
10. Measure six inches of line from the slotted tab and cut
Replace every 25
hours or yearly
X X
X
WARNING:
WARNING:
head for any damaged or worn parts.
threaded area of the spool.
rows on the top of the spool until the line reaches the
Do not wind the line beyond the
edge of the spool.
edge of the inner ring.
slotted tabs on the spool.
the line at that point.
Clean every 25
hours or yearly
X
21