Scheppach OSM600 Traduccion Del Manual De Instrucciones Originale página 23

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly re-
pairs, reduce downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the ma-
chine at all times and store it in a plastic cover to pro-
tect it from dirt and moisture.
Read the instruction manual each time before operat-
ing the machine and carefully follow its information. The
machine can only be operated by persons who were in-
structed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of woodwork-
ing machines.
We cannot accept any liability for damage or accidents
which arise due to a failure to follow these instructions
and the safety instructions.
2. Device description
1. Tool spindle
2. Worktable
3. ON/OFF switch
4. Fixing screw
5. Vacuum connector
6. Cover
7. Rubber sleeves
8. Table inlets
9. Abrasive sleeves
10. Sanding belt attachment
11. Abrasive belt
12. Attempt
13. Sanding belt tensioner
14. Regulating screw
15. Locking levers
3. Scope of delivery
• 4 x rubber sleeves
Length 115 mm, Ø 19 / 26 / 38 / 51 mm
• 5 x abrasive sleeves
K80, Ø 13 / 19 / 26 / 38 / 51 mm
• 5 x table inlets
Ø 13 / 19 / 26 / 38 / 51 mm
A. Locking screw ( abrasive belt)
B. Washer
C. Locking screw (stop)
D. 3 x spindle disks Ø 16 / 22 / 44 mm
E. Hexagon nut M8
F. Allen key SW13
www.scheppach.com GB | 23