Scheppach OSM600 Traduccion Del Manual De Instrucciones Originale página 27

6. Technical data
Dimensions L x W x H
Speed
Oscillation stroke
Belt dimensions
Belt Speed
Grinding height max.
Spindle ø
Table Size
Table Tilt
Vacuum connector ø
Weight
Motor
Power
Subject to technical changes!
Total vibration values determined in accordance with
EN 62841
sound pressure level L
PA
uncertainty K
pA
sound power level L
WA
uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
7. Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately.
• Later claims will not be recognised.
• If possible, store the packaging until the warranty
period has expired.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts.
465x420x500 mm
2000 1/min
16 mm
610 x 100 mm
8 m/s
90 mm
12.6 mm
410 x 425 mm
0° - 45°
38 mm
12.9 kg
220-240 V~ / 50 Hz
450 W
76 dB(A)
3 dB
89 dB (A)
3 dB
www.scheppach.com
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
8. Assembly / Before commissioning
m WARNING!
Always pull the power plug before making adjustments
to the equipment.
• All covers and safety devices have to be properly
fitted before the equipment is switched on.
• It must be possible for the grinding/sanding belt and
disk to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you actuate the On/Off switch, make sure
that the abrasive paper is correctly fitted and that
the equipment's moving parts run smoothly.
Connection to vacuum suction.
The use of an extraction system is recommended.
8.1. Tool changes (Fig. 3 - 8)
m ATTENTION! Turn off the machine and discon-
nect the main plug.
When changing tools make sure to have all parts
cleaned.
Prepare the appropriate tool and mount it as follows:
1. Insert cover (6) in table (2)
2. Insert stage plate (8) into the cover (6) (Fig. 4)
3. Attach the lower spindle disc (7) to the spindle (1)
(Fig.5).
4. Slide the abrasive sleeve (9) onto the rubber
sleeve (7) (Fig. 5).
5. Apply the disc (D) (use the correct measurements)
(Fig. 7).
6. Put on the hex-nut and tighten it with the hook
wrench (F). (Fig. 8)
GB | 27