Descargar Imprimir esta página

MTD 550 Serie Manual Del Operador página 9

Ocultar thumbs Ver también para 550 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Starting the Engine
To start the edger's engine,
proceed
as follows:
1.
Attach the spark plug wire to the spark plug. Make certain
the metal cap on the end of the spark plug wire is fastened
securely over the metal tip on the spark plug.
2.
Move the blade depth
control
lever back to the START
position
in the adjacent
(top) notch.
3.
Depress the primer bulb three times, pausing two to three
seconds between
each push. In cold weather
(below
50°F
/19°C), it may be necessary to depress the primer
bulb four
or five times.
NOTE: Using the primer to restart a warm engine
after a
short shutdown
is usually not necessary. Doing so may
result in a flooded
engine.
4.
Standing
behind
the edger, depress the blade control
and
hold it against
the upper handle with your left hand.
i_
WARNING!
This blade control
mechanism
is a
safety device. Never attempt
to bypass its operation.
5.
With your right hand, grasp the recoil starter handle and
slowly pull the rope outward
until engine
reaches the start
of its compression
cycle (the rope will pull slightly
harder at
this point).
6.
After slowly allowing
the rope to recoil, pull the rope with
a rapid, continuous,
full arm stroke. Keep a firm grip on
starter handle throughout
the entire
stroke.
7.
Allow the starter handle to slowly return to the eyebolt.
NOTE: If the engine fails to start after three pulls, depress
the primer an additional
two times before pulling
the
starter rope again.
Stopping TheEngine
To stop the edger's engine,
release the blade control.
Edging
WARNING!
The rotating
cutting
blade may throw
objects and cause personal injury. Keep the area
clear of bystanders
and do not operate
it without
the guards in place.
_
WARNING!
Do not lower the blade if it is over
concrete, asphalt,
rocks or the like. The blade can
strike the supporting
surface, resulting
in personal
injury or property
damage.
To begin edging,
proceed
as follows:
Move the edger to an area to be edged,
making
sure that
the left rear wheel is on a hard surface and the blade is over
the area to be cut. See Fig. 5-1.
Figure 5-1
2.
With blade control
lever in START position,
make a pass
along the area to be edged
before proceeding
to the next
notch. The further
forward
blade depth control
lever is
moved, the deeper or lower the blade will cut into the
ground.
Several passes may be necessary to obtain the
desired depth
of cut. Do not lower the blade more than
one depth
notch at a time without
making
a pass.
3.
For best results, proceed
slowly along the path being
edged. Slowly moving
edger back and forth through
the
cutting
area, again making
sure to keep the left rear wheel
on the hard surface and the blade in the cutting
path, close
to but not touching
the edge of the hard surface.
4.
Once you have finished
edging
the selected area, raise the
blade control
lever back into the START position,
move to
the next area to be edged, and proceed
again from step 1.

Publicidad

loading