SCANCOOL GUR 600 W Instrucciones De Mantenimiento página 33

EN
- Application of a bottle cap catcher:
To Place:
1 – Insert lower groove into the bracket
2 – Pull itu p and engage the upper groove
on the bracket
3 – Lower the catcher
3.5. BEFORE SWITCHING ON
Before you start the appliance for the first time, you should clean it inside with a
non-alkaline cleaning solution (do not use corrosive products) and then dry
thoroughly. The equipment must be disconnected from the mains while this is
done.
3.6. CONNECT TO THE MAINS
Before connecting the equipment to the mains, check that the voltage and
frequency are in accordance with the specifications on the rating plate. The
appliance must be connected to an earthed socket; ensure that the connecting
cable does not become entangled.
If the length of the cable is not enough, it should be replaced by a qualified person.
Do not use an extension cord.
34
To Remove:
1 – Make the catcher go up
2 – Dislodge from the upper groove
3 – Lower the catcher until it comes out of
the lower bracket