GE 21 Manual Del Propietario E Instalación página 20

Installing and removingpreviouslyinstalled decoratorpanels.
Read these instructions completely and carefully.
Removing the Handles
In order to remove the decorator panels and replace
with new panels you need to remove the handles.
A T-20Torx driveris neede_
O i,oosen and remove the
2 screws
in the
Top Trim.
O I,oosen and remove the 2 screws in the bracket
that attaches the Handle to the top of the Dora:
_ (;rip the Handle firefly and slide
upwards.
O S 0 S O ' S 0
The ke_h le,d ts n the Handle,dide ffthe
b/l[[ons on [lie dooi:
0 Open the door and slide out the decorator
panels.
TopTrimScrews
BracketScrews
Bracket
Bu_ons
Slots
Inserting the Door Panels
Before installing the decorator panels, make sure they have been routed out in the proper areas as shown in the
beginning of this section. Slide in the panels to perform a trial fit before fastening down the Handle and Top Trim.
Installing the Handles
Once the panels are fitted properly, install the Handle and Top Trim.
0 Slide the keyhole slots on the Handle down
onto the buttons mounted to the fi_ce of the
doo_: Slide the Handle downward tmtil the
bracket at the top of the Handle fits flush on
the top of the d{}{m
O Replace the two screws in the bracket that
attach the Handle to the top of the Door and
tighten the screws to 45 in-lbs torque,
O Replace the Top Trim making sm'e it fits over
the Side Trim and that the locating tabs fit the
inside of the Handle profile,
O Replace the Top Trim screws and tighten to
30 in-lbs torque.
20