network connection.
9. Firmware information allows you to check the software or
install updates on the device.
Control unit use
On/Off button: Press this button to
power on or off the AmbiGlow. Press it for
approximately 5 seconds in order to set
the device on pairing mode or to reset it.
Scene modes button: Press this button
for the AmbiGlow to display scene modes
and switch between them.
Music/Sound sync & Color capturing:
Press this button to set the AmbiGlow
lightning in sync with music or sounds
that
the
control
unit
microphone
captures. Press it again to activate the
color capturing function.
Warnings
• Please, strictly follow this user manual to install and use the
product to avoid accidents.
• Do not disrupt the bulb or modify any component.
• Turn off the power and the main electrical panel before
installing or doing maintenance tasks to avoid damage from
electric shock.
• Do not install the lamp on unstable or unsafe ceilings.
• Do not cover the lamp with blankets or similar objects.
• Do not handle the bulb or any other lamp component for
installation, repairing or checking unless you are a qualified
electrician. Wire connecting must follow IEE electric
standard or any other valid national standard.
• Do not install the lamp above hot or wet surfaces.
Maintenance recommendations
• Regularly clean the product with a dry cloth. The product
must be disconnected or
switched on when you clean it.
• Keep the connectors and/or ports free from dust, lint, etc.
to prevent improper
connections.
• Avoid breaking the device. Do not put objects over it or
bend it too strong.
• If the product includes a cable do not bend it too strong
and do not pull from it to unplug
the product.
• Do not wet the product. Keep it always in a dry place, away
from humidity.
• When not using the product, store it in a place free from
dust, dirt, lint, liquids, etc.
• If water or other liquids enter the product interior, unplug
it immediately from any
attached power source or device it is connected to.
• Avoid dropping or hitting the product. It might be
damaged.
• Do not use the product for anything other than its intended
use.
• Please recycle the product in accordance with local
environmental laws and regulations.
Safety information
Please read the following instructions before using the
device for the first time: