Danby DCR031B1WDD-RF Manual Del Propietário página 5

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length of
time during this process, it must be allowed to remain upright
for 6 hours before plugging it in to avoid damage to the internal
components.
1. Remove the hinge cover and the upper hinge. Remove the
hinge hole covers from the top left side of the cabinet. Remove
the freezer door from the cabinet.
2. Remove the central hinge from the middle of the cabinet.
Remove the refrigerator door from the cabinet. Remove the
screw hole covers from the left side of the cabinet and install
them in the screw holes on the right side of the cabinet.
3. Remove the hinge hole covers from the top left side of the
freezer and refrigerator doors and install them in the hinge
holes on the top right side of both doors.
4. Remove both adjustable feet. Remove the lower hinge from
the cabinet. The lower hinge must be turned over before being
reinstalled.
5. Install the lower hinge on the left side of the cabinet. Install
the refrigerator door and central hinge. Before tightening
the screws on the central hinge, ensure than the top of the
refrigerator door is level with the cabinet and that the rubber
gasket is making a good seal. Install both adjustable feet.
6. Install the freezer door. Install the upper hinge on the top
left side of the cabinet. Before tightening the screws on the
upper hinge, ensure that the top of the freezer door is level
with the cabinet and that the rubber gasket is making a good
seal. Install the screw hole covers on the top right side of the
cabinet.
IMPORTANT
Ensure that the door is fully closed when the
appliance is in operation. Failure to fully close
the door can lead to excessive condensation
and potential water damage to fl ooring under
the appliance. Danby will not be responsible for
damages from misuse.
4
1
2
3
4
5
6