Publicidad
Idiomas disponibles
Idiomas disponibles
Extraction speed (power) 1 starts and key T4 flashes, indicating that hood calibration has started and will last for about 5
minutes.
Note: to interrupt calibration, press T4 for 5 seconds; the calibration will be invalidated and must be repeated.
Note: when the product is powered up for the first time, calibration is performed automatically: T4 flashing; wait 5 minutes
for calibration to end.
Hob selection
Note: this operation must be performed in standby mode, i.e. 1 minute after the motor has been switched off Press key
T10+T11 for 5 seconds.
Keys T10 and T11 light up.
Press key T10 in the case of a gas hob - the key flashes, indicating successful selection.
Press key T11 in the case of an electric hob - the key flashes, indicating successful selection.
The pressed key will flash for 3 seconds, indicating that the selection has been saved.
INSTRUCTIONS FOR WI-FI CONNECTION
REMOTE CONTROL/"Whirlpool 6th Sense Live" APP CONFIGURATION PROCEDURE
The Whirlpool 6th Sense Live App allows you to operate and control the appliance remotely using an external device. To
enable the appliance for remote control, it is necessary to perform the connectivity configuration procedure. This procedure
is necessary to register the appliance and connect it to the home network. The configuration procedure only needs to be
performed once. It will be necessary to perform it again only if the router properties change (network name, password or
data provider).
1.1 BEFORE STARTING THE CONFIGURATION PROCEDURE
1.
To perform the procedure, you will need: A Smartphone or Tablet with Android 7.0 (or higher) operating system, or an
Ipad or IPhone with IOS 11 (or higher) operating system; • a Wi-Fi router b/g/n 2.4 Ghz connected to the Internet
(check with your Smartphone or Tablet that the signal strength of your home wireless network is good in the place
where the appliance is installed).
2.
Download and install the free Whirlpool 6th Sense Live App on your Android Smartphone or Tablet or on your iPAD/
iPhone from the online store. The App will provide all the necessary instructions for the installation procedure. If you
do not have an account yet, create one and register for the service (by signing up to the legal terms) in order to be
able to use all the features available in the App.
3.
Register your appliance by following the instructions provided by the App. For the registration procedure, the SAID
(Smart Appliance IDentifier) code, indicated on the appliance's label, will be required. The SAID code is a combination
of numbers and letters (10 characters). Write down the SAID code of your appliance here:
SAID ............................................
1.2 BEFORE STARTING THE CONFIGURATION PROCEDURE
• Before starting the installation, switch on the router and check that the wireless signal from your home network
reaches the appliance. To check the strength of the Wi-Fi signal, use a Tablet or Smartphone connected only to the
Wi-Fi router, disable all other connections and bring the device near the appliance. Open any Internet page in a
browser and check that it loads quickly and correctly. If the home Internet connection works properly but the page
does not load, it may be necessary to install a Wi-Fi extension device (not included with the appliance).
• If the router supports WPS 2.0 (or later versions), follow the automatic configuration procedure to connect the appli-
ance to the router. If the router does not support WPS, follow the manual configuration procedure.
Follow the instructions of the Whirlpool 6th Sense Live App, which appear on your Tablet or Smartphone, to
connect the appliance to your Wi-Fi network.
Or, perform one of the automatic or manual connection procedures described in the following paragraphs.
7
Publicidad
