Songmics Vasagle LSD018/101/102 Manual De Instrucciones página 17

EN
Setting & Use
Safety Information
Please read this guide before installing or operating the system.
Do not allow children to climb or play around this product.
Do not drag the desk on any surface to avoid damage.
This product should be away from water or any corrosive materials.
If any part is missing or damaged, please contact the seller for help.
The system needs to be restored to the factory setting before its first run or after the replacement of any part.
All hex-head screws should be manually tightened; self-tapping screws should only be tightened by a power drill.
Always check that the screws used to attach components to the work surface are shorter than the thickness of the table.
System Reset
When "RST" is displayed on the handset screen, it means there is an issue with the system and it needs to be reset.
Press and hold the "↓" button until the desk moves down to the lowest position.
Ÿ
Let go of the "↓" button, and then hold the "↓" button again for 5 seconds.
Ÿ
Do not let go of the "↓" button until you hear a "beep" sound, indicating that the system reset is complete.
Ÿ
Normal Height Adjustment
Press and hold the "↑" or "↓" button to reach the desired height.
Setting the Memory Function
When the desk is at the height that you want it to memorize, press and hold the "S" button until "S-" is displayed and the "-"
flashes on the screen. Then press the "1" button. Now, preset position 1 is memorized.
Repeat the above procedure for preset positions 2 & 3.
Memory data remains even after the desk is turned off or the system is restarted.
Restore to Factory Settings
If you want to restore the parameters to the factory settings, please proceed as follows:
Press and hold both the "↑" and "↓" buttons for 10 seconds.
Ÿ
There will be a beep sound.
Ÿ
The reset is finished, and the desk is ready for use again.
Ÿ
Set the Height Limit
Press and hold both the "↑" and "↓" buttons for 5 seconds. When the desktop reaches your desired height and there's a beep
sound, it means the maximum or minimum height limit has been set successfully.
The maximum height is set when the table is in the upper position, and the minimum height is set when the table is in the lower
position.
Deactivate the Height Limit
Method 1: Restore to factory setting
Method 2: Set the table to the limit height, and press and hold both the "↑" and "↓" buttons again for 5 seconds. When you hear a
beep sound, the height limit set beforehand is deactivated.
Desktop Height
17
Setting 3 Preset Heights