GE 21 Manual Del Propietario Y Instalación página 17

Installation
Instructions
Refrigerator
Models 21 and 25
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT- save t hese instructions for l ocal
inspector's use.
• IMPORTANT - Observe all g overning codes and
ordinances.
• Note to Installer- Be sure to leave these instructions with
the Consumer.
• Note to Consumer- Keepthese instructions for future
reference.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Completion time- Refrigerator Installation
20 minutes
Water Line Installation
30 minutes
Anti-Tip Bracket Installation
20 minutes
• Proper installation isthe responsibilitg of the installer.
• Product failure due to improper installation is not covered
under the Warrants.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door, seeStep 1 in the
Reversingthe Door Swing section.
• To remove the freezer drawer, see the Removingthe
FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.AGE water supplg kit
(containing tubing, shut-off valve,fittings and instructions)
is available at extra cost from sour dealer,bg visiting
our Website at GEAppliances.com (in Canada at
www.GEAppliances.ca) or from Parts and Accessories,
800.626.2002 (InCanada 1.800.661.1616).
17
MATERIALS YOU MAY NEED (notincluded)
LagBolts
Drill Bit Appropriatefor Anchors
AnchorSleeves
ForAnti-Tip Bracket Mounted on CONCRETE Floors Only
TOOLS YOU MAY NEED
AdjustableWrench
3/8 and5/16 Socket
Ratchet/Driver
1/4 OuterDiameter
Compression N ut
andFerrule (sleeve)(icemaker
modelsonly)
Phillips-Head Screwdriver
3/32 , 1/8 and 1/4 Allen
wrenches
1/8 Drill Bit and
Electricor HandDrill
Tape measure
Pencil
1/4 Nut Driver
Wire Cutters
Level