GE 21 Manual Del Propietario Y Instalación página 26

Installation Instructions
REPLACING THE FREEZER DRAWER
(on some models}
Two people may be required to complete
this procedure.
nl
REPLACE THE BASE GRILLE
(if removed earlier)
CAUTION: Be careful not t o
overtighten the screws since this mmg crack
the grille.
Align the base grille and replace the 2 Phillips-
head screws on either side of the base grille.
r2l ATTACH AND SECURE THE DRAWER
FRONT TO THE SLIDES
_-l Pull out the rail assemblies to the full length on
each side of the cabinet.
D
There are two tabs on each drawer rail and
two slots on each rail assemblg on the
refrigerator. Align the drawer rails with the rail
assemblies, tilt the drawer toward the
refrigerator, and seat the tabs into the slots of
the rail assemblLl. Lower the drawer into
position.
Slot Tab
[] ATTACH AND SECURE THE DRAWER
FRONT TO THE SLIDES (CONT.)
[_] Replace the hex-head screws to secure
the drawer.
r31 REPLACE THE FREEZER BASKET
FA] Tilt the basket forward and lower it into the
drawer.
FBI Lower the freezer caddg ensuring the hook fits over
the front edge of the bottom freezer basket. Push
down to secure.
rc1 seat the basket onto the metal slide brackets and
over the swing locks.
[] Turn the swing locks from horizontal to vertical
position to lock the basket in place.
r_ Turn the divider slightlg to one side so the tabs
on the front fit into the vent slots on the basket.
Position the divider so the back locating tabs snap
into place in the back vent slots.
26
\