GE 21 Manual Del Propietario Y Instalación página 25

Installation Instructions
REMOVING THE FREEZER DRAWER
(on some models}
The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
ITI REMOVE THE BASKET
r_ open the freezer drawer until it stops.
r_ Lift the freezer caddg up.
r_ pull the divider forward until the rear locating tabs
are out of the slots. Turn the divider slightlg to the
side to release the front locating tabs and lift out.
r_ The freezer basket rests on the metal slide
brackets and is held in place with swing locks.
r_ Turn the swing locks from vertical to horizontal
position. Open refrigerator doors.
r_ Lift the basket up and rotate it toward gou.
Slide out from the side of the drawer.
o
[] REMOVE THE BASE GRILLE
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still not fit
through a doorwag, the base grille can be
removed.
_] Remove the 2 Phillips-head screws on either
side of the base grille.
_] Pull the grille straight out.
I_1 REMOVE THE DRAWER FRONT FROM
THE SLIDES
IA1 Remove the hex-head screw from each side
of the rail assemblg.
FB1 Tilt the drawer front toward the refrigerator
and lift out.
Rail
assembly
r_ set the drawer front on a non-scratching
surface.
[] Push the rail assemblies back into the cabinet.
25